I have a 95 Pontiac grand am gt L4 2.3 DOHC VIN D MFI (Manual) and im trying to find software for my laptop to get codes readings ect. i have the USB cable that plugs into the obd1 on the car but all these sofwares ive tried only work with all these different muscle cars and cant find one that will work with my (apparently rare) car. i dont know how to program any software so could someone tell me where i can get software to work with my car or tell me how to write my own program to get it to work
ive tried EFIlive V4 already and that doesnt work with my car and ive installed the correct drivers for the cable and stuff already please help
SOURCE: 2004 pontiac grand am
Sorry - which ones? A/C heating or engine cooling fans?
Check fuses to make sure they're still ok. Remove the ones for the fans - and replace to clear any corrosion off them.
If it's the cooling fans at the front, these are controlled by a temperature switch which may be faulty.
Locate it , and measure the conductivity between contacts when cold - and when engine is very hot. The switch should close at around 90 degrees - 3/4 of the temperature gauge.
If the switch is ok, the relays controlling the fans are probably corroded.
Sometimes mounted on the fan housing - follow the fan motor wiring directly to them.
Hope this helps.
SOURCE: 1995 pontiac bonneville 3800 v6
P0321 Spark Reference Circuit. The spark reference signal is used by the PCM to improve ignition timing accuracy during crank and at engine speeds of up to 1,200 RPM. The spark reference circuit allows the use of ignition control mode below 400 RPM, eliminating the need to utilize module mode during start-up, and also allows the PCM to calculate true crankshaft position in 1/6 the time that use of the fuel control reference signal would permit.
During normal operation, the PCM uses the spark reference signal to control ignition timing until the engine speed exceeds 1200 RPM, at which time the fuel control reference signal is used. There is no connection to the TCS.
If everything checks ok then the PCM is defective PCM.
SOURCE: how to reset the "service engine soon" light on a 2001 pontiac grand prix gt
you can go to advance auto and use there scanner for free to clear the code its called an obd2 connection or when you disconnect your battery you can touch your black negative cable to your red positive cable that connects to the battery and it will completley drain everything and reset but warning you if your trying to get the car through emissions your gonna have to drive the car 50 or 100 miles after you disconnect the battery each time..
SOURCE: Car Heater Not Working - Blowing Cold Air
also check to see if tube that runs your climate door is not pinched or broken. the vaccum tube that runs the climate door is behind and under the battery. i had same problem a year ago and the tube was partially cut. i fixed it by cuttinga piece of aquarium tubing and spliced it back together. one other thing.....check to see if your radiator over flow cap is tight. your cap maybe bad and or cracked this would also cause the problem.
144 views
Usually answered in minutes!
×