Remove the inner wheel wells or cut it back to get some access its tight that way though i would just remove the two of them its 10& 11 mm on the top sidde just let everthing hang , it is either 5.5 mm or a 7 mm . the speed sensor is in the transfer case for the 4x4 or on theh rear on the trans for 2wd
Glow Plug: Service and Repair
Glow Plug
GLOW PLUG
Special Tool(s)
Removal
1. CAUTION: Do not pull on the wiring to remove the glow plug connector or damage may occur.
NOTE: Only one glow plug connector shown.
Using the special tool, remove the glow plug harness.
2. NOTE: If coolant residue is found on the glow plug, a new glow plug sleeve may have to be installed.
Remove the glow plug.
Installation
1. Install the glow plug.
- Tighten to 19 Nm (14 lb-ft).
2. Clean and apply clean engine oil to the O-ring seals.
3. Using the special tool, install the glow plug harness.
There is a speed sensor on each front hub and one on top of the differential.
1,507 views
Usually answered in minutes!
×