Locate Thermostat on 2000 Grand Cherokee Limited

Question edited for clarity and order.

They are for preventative maintenance, and by the sounds of it, it is too late. Parts that knock and cause shaking need replacing. Have you checked that the engine mounting rubbers haven't parted?

https://www.google.com/search?q=2004+Jeep+Grand+Cherokee+SE.+How+to+locate+grease+points

..

Locate the spark plug wires in the Cherokee cylinder head. In the 4.0 liter engine, the spark plugs are below the coil rail assembly. On the 4.7 liter engine, the spark plugs are located under each corresponding engine coil.


Read more: How to Replace Spark Plugs in a Jeep Grand Cherokee ' eHow.com http://www.ehow.com/how_4484626_replace-spark-plugs-jeep-grand.html#ixzz27zi6736d

Hi there:
Check Grand Cherokee Jeep Limited 1999/2000, the CKP sensor is located on the right side (driver side) at the end of the engine block when you open the hood and facing the engine block..the sensor sits on the bell housing..It has its cable connector end pulled all the way to the left side of the engine block and connected there, so you may have to first locate and grab that connector cable end, near the oil filter at that left side at the end of the engine block , and then you feel and trace the connector cable all the way through the back of the engine block back to the CKP sensor on the right end side of the engine block in order to easily locate the sensor.



Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Locate the top radiator hose...follow it down to the motor...the housing that the hose connects to is where the thermostat is..usually there are 2 screws to remove and then it just comes up and the thermostat is inside

1. On 2000 Jeep Grand Cherokee 4.7L V8
2. Remove lower radiator hose clamp and lower radiator hose at thermostat housing.
3. Remove thermostat housing mounting bolts, thermostat housing and thermostat.

2000 Jeep Grand Cherokee 4.0l v6Note:on the In-line 6 4.0L model the thermostat housing is mounted at the top of the engine block next to the water pump.

the thermostat is in the housing where the top radiator hose goes onto the engine........ hope this helps........cheers

If you have a V8 the thermostat is located under the coolant inlet tube. The tube is located on top of the engine, in the front about center. The thermostat is hard to change. Locate the upper radiator hose on your radiator and follow it to the engine block it is located on the top front part of your engine and you must lean over the front and look down onto the block to see the thermostat housing.

Flasher isn't a "traditional" flasher anymore. It's a module, usually located under the dash to the right of the steering column.

follow top radiator hose from radiator to engine wear hose ends, it will be clamped to whats called the gooseneck, thermostat is under that. you will have to drain coolant, not all, maybe 1 half gal. before you remove it. 2 bolts new gasget new thermostat, just remember spring on new thermostat goes in engine.

When the engine is at operating temp check the electric cooling fan. If it is not moving then i would check the fan relay which is located under the right side headlamp. 9 times out of 10 this is the problem