Replaced water pump still heats up does anyone know where the bleeder valve is to see if I left air in it
C'mon man, girl, relax , this is not even a problem, did you change thermostat ? hope so, is it installed in the right position ? are your radiator hoses bad, replace if worn , soft, etc., with truck warming up watch to see if hoses collapse, if old replace anyway . use 50/50 coolant mix, are heater hoses ok, not leaking ?
SOURCE: I have a 1999 GMC Yukon Denali, 350 V8. I want to
check in the area above the rim of the oil filter...they're typically located very close to the filter.
k
SOURCE: What type of oil pump is on 1999 GMC Yukon V8 5.7L
If you are referring to the pickup screen tube size, it would be either a 3/4inch or a 5/8 inch Most rplacement pumps use the 3/4. If in doubt, buy the pump and pickup at the same time and get both of them in the same size.
SOURCE: 2003 Gmc envoy vortec 6 cylinder motor. where is
I dont heard about bleeder valve in the water/cooling system in this model; I am still not sure is the bleeding of the cooling system, manual says
"disconnect the coolant air bleed hose at the throttle body".
Hope this helps.
111 views
Usually answered in minutes!
thanks I am a mam I just wanted to make sure it was nothing serious lol
×