Back passenger window won't roll back up, Chevrolet Cavelier

Have you tried the drivers door "passenger door window switch" and the passenger "door window switch" to try and roll the passenger window up?When you do try to roll it up make sure the vehicle is running as you want the most voltage to the window motor.If both door switches would not roll the window up,try the following.
With the engine running hit the up window switch on the passenger door just as you give the door a HARD FIRM RAP.The window should roll up.It may take a few tries.DO NOT roll the window back down until you have changed or dissembled the window motor for a good cleaning.Also,check for broken wires at the door hinge area on both the drivers and passenger sides,pull each wire firmly looking for a broken wire.

you have to check your electrical system or the fuse linked to that area.

It sounds like it could be the window solenoid, or the window motor. It's unlikely the switches on both doors are bad. Check the solenoids and motors...

blewed fuse or bad connection or need a new motor

Either the regulator broke or the window came out of the channel.

It could be ether a wire problem window motor problem or its jamming up when its all the way down i have a similer problem with my passenger window on my two door blazer it works fine if i keep it up sOme but if i put it down all the way i have to take the door panle off and pry it up.

Window regulator.

Sounds like a weak motor to me.

the window fuses are in the fuse box
but i don't think that's the problem if a window will roll up but not down
or down but not up/////
open the driver door you will see a rubber tube going from the door to
the door jam open the rubber up ill bet you find a few broken wires
all you need to do is splice them back together

if you don't find any brakes in the fuse box the windows are setup
on breakers they might be bad Thar's always a first for every thing

hope this helps you
good luck
bob

most of the time its the motor