1998 Chevrolet Monte Carlo Logo
Anonymous Posted on Jan 19, 2013

98 monte carlo knocks while acceration

Engine pings while acceration

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 18 Answers
  • Posted on Jan 19, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Jan 18, 2013
Answers
18
Questions
0
Helped
1877
Points
63

Is your check engine light on?
possible causes are
cheap gas - egr valve - timing too high - carbon build up in cylinders

  • Anonymous Jan 19, 2013

    I checked all those execpt the egr valve

×

5 Related Answers

motor1258

Mike Butler

  • 6674 Answers
  • Posted on Mar 07, 2009

SOURCE: vacuum line diagram 98 chev monte

No sticker on underside of hood or on rad support showing that?

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Mar 24, 2009

SOURCE: 1996 monte carlo fault codes po300, 441, 705,

THESE ARE FROM THE GM CODE DIFINITION MANUAL, U NEED TO TAKE THIS TO THE DELAER, U HAVE SOME SERIOUS PROBLEMS TO GIVE THIS MANY CODES.

P0300 - Engine Random Misfire Detected
P0441 - Evaporative Emission Control System Incorrect Purge Flow
P0705 - Trans Range Switch Circuit
P1106 - Manifold Absolute Pressure (MAP) Sensor Circuit Intermittent High Voltage
P1133 - Heated Oxygen Sensor (HO2S) Insufficient Switching Bank 1 Sensor 1
P1441 - Evaporative Emission (EVAP) System Flow During Non-Purge
P1662 - Cruise Lamp Control Circuit
P1672 - Low Engine Oil Level Lamp Control Circuit
P1870 - Transmission Component Slipping

litoshop

Josue Almodovar

  • 298 Answers
  • Posted on Jul 28, 2009

SOURCE: 2002 chevy monte carlo won't start

this vehicle is equipped with a factory anti theft system if when you try to start the engine and the anti theft light is on then the starter won't start even if your check engine light is not on you would have to scan the body module to pin point the problem to see if it's the anti theft system or the starter, go to a auto parts store like auto zone or pep boys or western auto these store offer free scanning to there customers. if this information has been helpful please let use know good luck

Anonymous

  • 1 Answer
  • Posted on Jan 07, 2010

SOURCE: 98 monte carlo won't start,

same problem with my beretta. i was told its the alternator. they both have similar engines so im sure thats what it is.

Anonymous

  • 1206 Answers
  • Posted on Feb 01, 2010

SOURCE: My 98 Monte Carlo won't start. The lights, radio,

check the fuses there is a starter fuse, if not check the starter for power at the small wire if no power could be the relay,if you have power at the small wire its the starter that's bad.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to change knock sensor on 2001 Monte carlo

It is located under the intake manifold. The manifold has to be removed to access the sensor.
0helpful
1answer

Can you bypass a knock sensor on a 03 monte carlo 3.4 engine

You can never bypass a knock sensor. It will not run right if you try this
0helpful
1answer

Knock sensor removal

threre are 2. front and rear banks
bank 1 between starter and A/C compressor
bank 2 between transaxle and rh engine (firewall
drain coolant
unhook and remove sensor
0helpful
1answer

My 98 monte carlo rps wont go passed fourthousand

The PCM has a rev limiter that limits the engine to 4000 rpm when in Park or Neutral. This is to avoid engine damage during maintenance.
2helpful
1answer

NEED SPARK PLUG WIRE DIAGRAM FOR 98 MONTE CARLO

Check this diagrams for each engine size...

1998 Chevrolet Monte Carlo 3.1 liter V-6 VIN "M"

zjlimited_530.gif


1998 Chevrolet Monte Carlo 3.8 liter V-6 VIN "K"

zjlimited_531.gif


Hope this helps, and remember ask for additional details.
0helpful
1answer

My 03 monte carlo is very sluggish. The engine

P0404 Exhaust Gas Recirculation Circuit Range/Performance
P0502 Vehicle Speed Sensor Low Input
P0440 Evaporative Emission Control System Malfunction
hope that helps /a little beyond my expertise but theres your codes your looking for ;)
1helpful
1answer
0helpful
1answer

98 Monte carlo Z/34 cranks immediately then cuts

start by check ignition module(controls spark) do fuel pressure check to see if pressure within specs
1helpful
2answers

Out of blue 97 3.1 monte carlo engine start running bad

Check firing order 1,3,5 in the back next to firewall 2,4,6 in front check coil packs. If o.k you could have burnt valves. As for the knocking If its a heavy kock and it happens all the time even at idle it could be the main bearings on the crankshaft.
0helpful
2answers

2002 Monte Carlo SS starting when it wants

The Starter silenoid is probably what the problem is. And the knocking could that be a loose starter? The two problems doesn't seem connected.
God Bless Greg
Not finding what you are looking for?

106 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...