SOURCE: 2001 ford explorer sport trac 4 wheel drive wont work
Start the car
put in " N"
turn the 4X4 switch on
Then put in gear..
What do you see now?
Do the same in reverse when you take out of 4X4
SOURCE: Shock Absorber replacement 2002 Explorer Sport Trac
These are just regular shocks and not struts so they should come out with just common tools. You may need to soak the fasteners in penetrating oil for a while or, use heat tget the fasteners to break loose from the corrosion.
SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
SOURCE: 01 ford explorer sport trac rear timing chain diagram
They will not loan you the tools.....how else will they continue to rip off the average garage junkie and make lots of money?
1,271 views
Usually answered in minutes!
×