Transmission input speed sensor location

See the link for answer. 2013 dodge durango 3 6 liter transmission output speed sensor location

Hi there:
This code means that the transmission is slipping in high gear and the TCM (TRansmission Control Mocule) logic thinks it has incorrect ratio since it monitors input and output speed. Keep in mind that TCM uses input from the input speed sensor and output speed sensor to determine gear ratios. The TCM then compares the known gear ratio to the calculated gear ratio for the current range.


Check HERE test procedure.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.


Thank you for using FixYa, have a nice day.

The input an output speed sensors are located in the front of the transmission (the side facing the radiator). The input speed sensor is the one right below the rubber transmission cooler lines. the out put speed sensor looks exactly the same and is located more toward the drivers side of the transmission.

If you looking for a different sensor let me know. Thank you for using FixYa.com!

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

The input an output speed sensors are located in the front of the transmission (the side facing the radiator). The input speed sensor is the one right below the rubber transmission cooler lines. the out put speed sensor looks exactly the same and is located more toward the drivers side of the transmission.

If you looking for a different sensor let me know. Thank you for using FixYa.com!

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

The input speed sensor is right below where the cooler lines are clamped the the transmission. The output speed sensor looks exactly the same as the input and is located to the right ( as you standing in front of the vehicle) of the input speed sensor.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

There is an input and output speed sensor. They look identical. The input is just user the cooler hoses and the output is to the right as your standing in front of the ven. A one inch socket will work to remove them. The hole in the transmission will be slightly smaller than one inch. If you need an exact size you can remove one of them nod measure it.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

first disconnect the negative wire frim the battery. then look on the front side of transmission about middle ways to locate vehicle speed sensor. disconnect the electrical plug from sensor. remove the retaining bolt and lift the vehicle speed sensor from the transmission. replace in the reverse of removal.

A 3 SPD TRANS DOES NOT HAVE INPUT/OUTPUT SENSORS..ONLY A VEHICLE SPEED SENSOR..IT IS LOCATED ON TRANS EXTENSION HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..1 BOLT AND A WIRE CONNECTOR

The speed sensor is on the tailshaft of the transmission,on the passenger side of the car,it has 3 wires. The output sensors are located on the front of the transmission about mid-way up the housing & only have 2 wires. Note the output sensors are not responsible for vehicle speed. Only the output shaft speed is recorded. They are for finding the correct cvi(clutch volume index) only. If you have a cvi issue,the transmission is toast.

Here is some info. https://dodgeforum.com/forum/dodge-caravan/231988-97-grand-se-3-3-prndl-neutral-switch.html