The switch on the drivers door is probably faulty and will have to be replaced, but to confirm this, you first have to get at the back of the switch to test if power is there. If you want to try this yourself, instructions for removing the switch from the door panel are included in the car service manual (see Alldatadiy.com).
It is either the wiring in the switch or dead actuator.
SOURCE: Power Door Lock Problem
The last post by maddog1321 was exactly what I had with my right rear door. The electric locks would not lock and unlock, and you almost couldn't do it manually without my feeling I was about to break something. I took the door panel off, oiled everything and got no relief. Finally, I saw the above post and drilled out the aft-most pop-rivet. THE WINDOW WORKED PERFECTLY! I didn't drill out the forward (closest to the handle) pop-rivet because I wanted to do one at a time so the solenoid would not fall out of place. I then put a new pop-rivet in place of the one I drilled out. I then reinstalled everything and the locks work like new.
SOURCE: Power windows inop
a brake in ur wires in the door,on a 04 grand i had the same problem,in the wire harness were the junction box is rust had broken one of the male prongs
SOURCE: door locks and power window
Just did this procedure I got from coloradofans.com forums:
"any type of power/voltage change
seems to trigger this issue
The most common symptom is power
locks fail and only the driver window quits, however that is on the
extended cab.
Steps to fix and it works every time.
take
door panel off driver's door
Disconnect the wiring attached to window
and power lock control unit
disconnect battery cables
connect
the negative to the positive cable(((NO BATTERY CONNECTED)))
This
will act to short residual voltage in the system
5 minutes later
place
the key in the ignition and turn to the run position
connect the
wiring to the window/lock controller
connect the negative cable to
the battery
then the positive
open drivers side door
turn key
to the off position((do not remove yet)) you should get a series of
dings through speakers telling you the key is still in the ignition
once
it begins dinging pull the key out and you should hear the door lock
solenoids trigger and the windows should work." - Coloradofans.com forums
SOURCE: Similar electrical issues with driver's side
CHECK FUSES FOR POWER WINDOW,CHECK FUSE FOR POWER MIRROR AND CHECK FUSE FOR POWER DOOR LOCK.IF FUSE OKAY DOOR CONTROL MODULE FAULTY ITSELF.
1,822 views
Usually answered in minutes!
×