Help please on this. Drive with 4 yr. old in pass. seat...not sure which airbag its talking about. THANK!
Passenger Air Bag Deactivation (PAD) Switch
The passenger air bag deactivation (PAD) switch:
------------------------------------------------------------------------------------------
Prove Out the System
Prove out the system means to turn the ignition switch from the OFF to the RUN position and visually monitor the air bag indicator with the air bag modules installed. The air bag indicator will light continuously for approximately six seconds and then turn off. If an air bag supplemental restraint system (SRS) fault is present, the air bag indicator will either:
The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the RUN position. This is the time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and an SRS fault exists, a chime will sound in a pattern of five sets of five tone bursts. If this occurs, the air bag indicator will need to be repaired before diagnosis can continue.
----------------------------------------------------------------------------------------
Active Commands
This command allows the technician to verify operation of the air bag indicator, passenger air bag deactivation (PAD) lamp and chime. When the air bag output command is executed, the indicator, the PAD lamp, chime and the chime are activated simultaneously for approximately four seconds. All devices are deactivated automatically.
Active Commands
This command allows the technician to verify operation of the air bag indicator, passenger air bag deactivation (PAD) lamp and chime. When the air bag output command is executed, the indicator, the PAD lamp, chime and the chime are activated simultaneously for approximately four seconds. All devices are deactivated automatically.
Restraints Control Module (RCM) Diagnostic Trouble Code (DTC) Priority Table
DTC a
LFC b
Priority
Description
Action To Take
—
—
1
The Air Bag Indicator is Illuminated Continuously — RCM Disconnected, Inoperative, or Lost/Low Ignition Feed
GO to Pinpoint Test A .
B1342
24
2
RCM is Faulted
GO to Pinpoint Test B .
B1231
19
3
RCM Crash Data Memory Full
GO to Pinpoint Test C .
B1921
21
4
RCM Bracket Ground Resistance High
GO to Pinpoint Test D .
C1414
29
5
Incorrect Vehicle Identification Code
GO to Pinpoint Test E .
B1887
15
6
Driver Air Bag Circuit Shorted to Ground
GO to Pinpoint Test F .
B1916
15
7
Driver Air Bag Circuit Shorted to Battery or Ignition
GO to Pinpoint Test G .
B1888
16
8
Passenger Air Bag Circuit Shorted to Ground
GO to Pinpoint Test H .
B1925
16
9
Passenger Air Bag Circuit Shorted to Battery or Ignition
GO to Pinpoint Test I .
B1932
32
10
Driver Air Bag Circuit Resistance High
GO to Pinpoint Test J .
B1933
33
11
Passenger Air Bag Circuit Resistance High
GO to Pinpoint Test K .
B1934
34
12
Driver Air Bag Circuit Resistance Low
GO to Pinpoint Test L .
B1935
35
13
Passenger Air Bag Circuit Resistance Low
GO to Pinpoint Test M .
B1871
25
14
Passenger Air Bag Deactivation (PAD) Switch Fault
GO to Pinpoint Test N .
B1884
27
15
Passenger Air Bag Deactivation (PAD) Warning Lamp Inoperative
GO to Pinpoint Test O .
B1890
27
16
Passenger Air Bag Deactivation (PAD) Warning Lamp Short to Battery
GO to Pinpoint Test P .
B1892
—
17
Air Bag Tone Warning Indicator Circuit Shorted to Ground or Open
GO to Pinpoint Test Q .
B1891
—
18
Air Bag Tone Warning Indicator Circuit Shorted to Battery or Ignition
GO to Pinpoint Test R .
B1869
Tone c
19
Air Bag Indicator Inoperative
GO to Pinpoint Test S .
B1870
Tone c
20
Air Bag Indicator Shorted to Battery
GO to Pinpoint Test T .
—
—
—
No Communication with the Restraints Control Module
GO to Pinpoint Test U .
a DTC: Diagnostic Trouble Code, retrieved using New Generation Star (NGS) Tester or equivalent.
b LFC: Lamp fault code, flashed on air bag indicator.
c Tone will sound only if additional DTCs are present.
×
SOURCE: S class 320cdi explain warning light pass airbag off
as the driver is supposed to be responsible for the safety of the passengers in transit,mercedes (are the only maker),decided that it would be better this way round.its not an airbag light,its a seatbelt warning light.(person sitting down with a ********)
SOURCE: remove the ftont seats for carpet replacement on 2002honda odys
WELL DISCONET BATTERY WAIT ABOUT FIFTEEN MIN THAT SHOULD LET THE POWER OUT ANY BE CARE FULL STAIK ELEC CAN SET THEM OFF BUT HAVE NOT SEEN ONE YET.
SOURCE: I Replaced Leather seats with airbags with cloth
hi.
the airbag check system still thinks that there are airbags in the seats. when it does not get the right signal from the seats it flashes a fault. the dead head plug ends in the new seats are probably just blanking plugs that are not actually completing the circuit. unfortunately, you probably need the system to be reprogrammed so it does not check for these seats. i would look in the phone book and ring a few of the smaller "back street" garages to get a price for this to be done as it is going to be far cheaper than the dealer. the job should tace under 30 minutes to do. DO NOT make any attempt to transfer the airbag system from the old seats into the new ones. my friend once tried this. when he reconnected the battery his nice new seats exploded.......airbags are very dangerous and need to be dealt with properly. good luck. BE SAFE
2,812 views
Usually answered in minutes!
×