2000 Ford Focus Logo

Related Topics:

Anonymous Posted on Dec 18, 2012

Change reversing light bulb on ford focus - 2000 Ford Focus

5 Related Answers

Anonymous

  • 150 Answers
  • Posted on Jun 16, 2008

SOURCE: how to change reverse light bulb on ford fiesta lx 1999

you have to open the boot and go in through that way. you know where the lights are? lift the carpet bit back and you should be able to do it that way. havent tried it myself but going to try and change mine tonite

Ad

Anonymous

  • 1 Answer
  • Posted on Jan 17, 2009

SOURCE: change rear signal bulb on 2002 ford focus wagon

Open the rear tailgate There are 2 screws that hold light housing in place.. Remove the screws then pull the housing outwards till the clip behind it springs. You then need to knock the housing sideways (outwards) to free the 2 prongs that attach housing to the car body.
Unclip the rear housing from the back of the light unit & change the bulb.

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Jan 27, 2009

SOURCE: Brake light change on Ford Focus, 2002.

piece of cake ,two minutes

Anonymous

  • 1 Answer
  • Posted on Aug 18, 2009

SOURCE: ford focus reversing lights stopped working

Probably sorted by now but in case anyone gets the same problem. Check all the red fuses in the main fuse box, not just the one the handbook says it should be. The main fuse box is behind the glove box...push in the sides and the gb will drop down....the fuse box is facing you.

Anonymous

  • 4044 Answers
  • Posted on Aug 27, 2009

SOURCE: how do you change rear brake light bulb in a Ford

You will need to look in trunk and pull back the covering over the light area on the side you need to replace. Once exposed, look for the wires going into the light housing and twist the plug to unlock it and remove the bulb. Twist and remove the old bulb or Pull the bulb out of the socket. Reverse the process to install the new bulb and replace the socket.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
1helpful
1answer

Change reversing light bulb on ford focus

open trunk and fold covering carefully removing plastic slide in or screw bolt. Light should be in the open. The back of the light holder would be visible. take the light socket and turn holding it firmly .The light should be a plain 12 volt bulb 1075 or 1025.reverse procedure to put light in
0helpful
2answers

2005 Ford Focus- Blinkers, Brake lights and hazards don't work -just change the bulbs and they still don't work. Help!

That should be on two different fuses, but everything goes thru the turn signal switch.
The switch might be faulty. A mechanic would check for voltage there.
0helpful
1answer

Reversing light not working?

make sure its earthing correctly
1helpful
1answer

Reverse light does not work, checked bulbs and fuse and they look good, any suggestions?? 2001 ford focus sedan.. thanks

If the bulb and the fuse are good, (the fuse will affect other circuits as well, not only the reverse lights), your next stop is the reverse light switch. It is located on the gearbox and is a switch with two wires coming from it. Remove the wires and touch them together and see if the reverse light comes on with the ignition on. If they do, you need to replace the switch.
0helpful
1answer

How to change a front light bulb

p, li { white-space: pre-wrap; }
  • Ensure that the headlights on your Ford Focus are off by checking you have turned the headlight control all the way to the off position. Make sure your car is off and the keys are out of the ignition, so the daytime lamps are also off.
  • Open the hood using the hood release handle located inside the vehicle under the steering wheel on the left side of the instrument panel. Walk around to the front of your Ford Focus and release the auxiliary latch located under the front of the hood. Lift the hood and secure it in place with the yellow end of the hood's strut in the designated holes.
  • Locate the bulb cover found just behind the headlight assembly and remove it by turning it counterclockwise. Swivel the wire clip that hold the bulb and connector in place out of the way by turning it to the left.
  • Pull out the headlight bulb with its electrical connector straight out from the headlamp assembly.
  • Disconnect the bulb from the connector. Later editions of the Ford Focus may have a retaining ring that lies between the bulb and electrical connector. Simply remove this retaining ring by twisting it off with a counterclockwise turn.
  • Install the replacement headlight bulb in reverse order of removal. Use a HB2 replacement bulb for models older than 2004 and a HB5 bulb for models produced since 2005. Replace the wire clip and bulb cover, as well.
  • Turn on your Ford Focus and check that the headlights are working properly after closing the hood.
0helpful
1answer

Replace the light for reversing

There are generally two bulbs, one on each side of the rear end, which light up when you put the car in reverse. Maybe both are bad? There is also a light switch attached to your gear shifter, may well be part of a larger switch unit which precludes you from engaging the starter unless you are in park or neutral. I would start by checking the bulbs, then ask a dealer to show you what the switch looks like and where it is located. If the back up lights flicker a bit as you jostle the shifter I would suspect the switch.
0helpful
1answer

Reversing light on my ford focus (51 plate) dose not work i have no voltage i have changed the reversing switch still not solved it can anyone tell me which is the live wire

the switch is in fact the earth when you select reverse it gronds the wire, so to test take lead off and earth it, there will be a contant live to the bulb with the ignition on, if when earthed the light works the fault is with the switch, which could be an adjustment problem, or a defective switch. if does not work when earthed check the live to the bulb then check fuse
7helpful
3answers

How do you change rear brake light bulb in a Ford Focus

You will need to look in trunk and pull back the covering over the light area on the side you need to replace. Once exposed, look for the wires going into the light housing and twist the plug to unlock it and remove the bulb. Twist and remove the old bulb or Pull the bulb out of the socket. Reverse the process to install the new bulb and replace the socket.
Not finding what you are looking for?

129 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...