Wher is the ignition control module located in a jeep grand cherokee lorado

The ignition module is located underneath the distributor cap, while the ignition coil is mounted typically on the engine block on the same side about 6-9" away. The center spark plug wire will lead to the coil. The module can be found by removing the distributor cap, there is a wiring harness that plugs into it.

Jeep Cherokee Questions - where is the ignition control ...

Base (initial) ignition timing is NOT adjustable. Do not attempt to adjust ignition timing by rotating the distributor. All ignition timing functions are controlled by the Powertrain Control Module.Adjusting the timing on a Jeep Grand Cherokee requires special tools and an understanding of engine mechanics. Changing the timing on a Jeep Grand Cherokee with distributor-less ignition requires professional reprogramming of the powertrain control module. This guide covers Jeep Grand Cherokee models with distributed ignition only. you can go to this site and it will explain it. www.ehow.com/how_4521340_adjust-timing-jeep have a good day !!

Your 95 Jeep does not have an ignition control module. This ignition system has a exterior mounted ignition coil and also a pick up switch inside the distributor.

LOOK LIKE ALL JEEP GRAND CHEROKEE FROM 1995 TO 2001 HAS THE SAME TRANSMISSION.BUT HAS DIFFERENT TRANSMISSION CONTROL MODULES.SO I WOULD BUY EXACT YEAR MODEL VECHICLE TRANSMISSION.LOOK FOR NO SUBSTITUTES.

with this year Jeep any auto parts store or dealership will carry these relays

should be on both sides of the motor under a long black part called ignition coil

The Crankshaft Position Sensor (CKP) is mounted to the transmission bellhousing at the left/rear side of the engine block.

Check the ignition control module

in the tank

Try (repairpal.com) for prices in your area code.