Need to know what a p1450 code is
Hi there:
The first thing that I suggest could be replace the gas cap; also check a possible defective EVAP (Evaporative Emission Canister Vent solenoid). HERE the instructions.
DTC P1450 - Unable to Bleed Up Fuel Tank Vacuum
Monitors the fuel vapor vacuum and pressure in the fuel tank. The system failure occurs when the EVAP running loss monitor detects excessive fuel tank vacuum with the engine running (but not at idle).
Keep in mind that, if problem persists you will need a smoke machine to properly diagnose.
Hope this helps.
SOURCE: 2002 mercury mountaineer 4.0 starter relay location
The power distribution box is
located in the engine compartment.
The power distribution box contains
high-current fuses that protect your
vehicle’s main electrical systems
from overloads.
The starter relay is in position #56 of that box.
SOURCE: i have a 1997 mercury mountaineer i have no manual
the cover that is on the fuse box should have a diagram of the fuses on the inside cover are..under the hood you will find another fuse box remove that cover and look at it..may have both the diagrams for the boxes...hope this helps...
SOURCE: 1997 Mercury Mountaineer What is Catalyst Efficiency Below (Bank
it means the catalyst is worn out, the efficiency is monitored by sensors, when the Cat falls below a certain reading or "threshold" the code is generating telling u that u need a new catalytic converter.
SOURCE: i need to know how to change auto door lock code
i dont know if this will help you but to change the auto lock codes on a 94 mercury sablethat is set into your remote keyless entry system at the factory.you can program your own personal code to unlock the vehicle. this code does not replace the prminant code that is programmed into your system.
to program your own code 1) select five digits for your personal code. 2) enter the code the dealership gave you. 3) within five seconds, press 1/2. 4) within five seconds of pressing 1/2, enter your personal code, pressing each digit within five seconds of the previous digit.
the keyless system registers this second code. to open your vehicle, you can now use either code. the module only remembers only one personal code at a time. entering a second personal code will erase the first personal code, replacing it withe new second one.
to erase your personal code 1. enter the original code. 2. press1/2 within five seconds of step 1. 3. wait six seconds
the keless entry system auto erased your personal code and will only respond to the permenent one. i hope this helps
778 views
Usually answered in minutes!
×