The other day my remote unlock stopped working, no doors except the drivers door would lock electrically, no windows except the drivers window would go down electrically, and the interior lights will not go off as if there is a door open. Any recommendations?
If door switches are ok, check the courtesy light relay located just under the front passenger side(above the fuse box)
The button that pushed in when you close the door could be bad its literally like a $10 part and plugs in and is only held in with one screw. My interior lights used to flash on and off and i replaced that and now good as new, but you would need to figure out which door is doing it by pushing the button in manually
Unlock all of the Jeep
Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
587 views
Usually answered in minutes!
my lights and my locks turn on and off when driven down the road
×