My 1997 Dakota interior light stay on intermitant, I pulled both door jam switches and still stayed on!! Head light knob is off, slam doors hard a few times and they will go out. Very erratic I Replaced both switches and still happens, Could it be the light timer? Also about the same time this started my ABS/Park Brake lights lite up. Two Problems?
Thanks
Den-Den
1997 Dodge DAkota 4X4 Sport
1992 Dodge Stealth
Check for moisture under the interior carpeting.
I have see it cause this when the wiring gets wet on the connections from the door switches. Other wise you are going to have to get a meter and check all the wiring to each door and the lamp switch.
SOURCE: 2002 dodge dakota wiring problem
same issue... my battery "green" is not there..... I will replace battery tommorrow... I put a battery charger on it and it was low. hope this helps.
SOURCE: I need a diagram of the interior fuses for my '95 Dodge Dakota
I have a fuse chart. send email to [email protected] and I will forward
SOURCE: 1996 dodge dakota Abs and brake light stay on all the time on the
On a Dodge when you have a problem with the anti-lock brake system or the hydraulic brake system it turns both lights on. You need to have your truck inspected to find out which one has the problem.
SOURCE: audi a4 1.8t windows, interior light wing mirrors not working
Folks, Just found my problem ...... There's a flexible conduit (corrugated rubber sleeve) between the driver's door and the door arch which contains the wiring loom for the drivers door central locking/door speaker/electric windows/mirrors etc....discovered when I slipped off the sleeve that 4 cables in the wiring loom had broken due to repeated flexing when drivers door was opened/closed over the years (2001 Audi A4). Resoldered broken wires and insulated same....now working better than ever again ...ie dashboard back lighting seems brighter than it had been for some time? Also drivers door loudspeaker is back in action again (hadn't noticed that it had gone).
It's kinda difficult to reseat the rubber sleeving correctly after the repair job...will probably use some silicone sealant on the sleeve to ensure that there is no water ingress to wiring loom afterwards. I'm not too impressed with Audi design people after that, should have used cable that has a better flexibility rating (esp on drivers door!).
Paul.
SOURCE: thermostat
go to an autozone store, or similar auto parts store and they will show you exactly where it is and have a replacement you can purchase.
If you want to look yourself:
Check the hose from the radiator on the passenger side of the engine. It is in the housing where it meets the engine.
facing the engine,it is on the lower part of the block,passenger side.
please mark this as a fixya! thanks.
114 views
Usually answered in minutes!
×