Reverse gear signal wire, parking brake signal wire
SOURCE: Fix chevy 2000 S10 parking brake.
Some times the rotors are hard to remove.(rust) Just soak it with wd40 and use a big hammer or prybar. Try smacking it around the studs, But don't hit them. If you smack the part of the rotor that the regular service brake rides on you will warp the rotor. Just keep trying, you'll get it. Also if you mess up the rotor they really aren't that expensive to replace. Plus your old one is likely wore out anyways.
SOURCE: 1995 chevy silverado z71 no power to right tail light
check fuse.if good you got grounding problems or faulty turn signal switch.
SOURCE: Reverse out on 94 Chevy 1500
Look under the truck and check for loose or broken wires leading to the transmission, if this looks ok you probably have an issue with the transmission electrol control module, these units are about $100.00 used from a junk yard and you will be taking a chance since this may not solve the problem, make sure the transmission filter is not clogged or fluid level is low.
SOURCE: need a wiring diagram for a chevy s10. brake
your power starts at the brake light fuse,check with a test light,then proceed to stop light switch on brake pedal under dash,one wire will be hot when when you check it with your test light, the other won't be until you press down the brake pedal then the power flows through to the second wire,if no power to second wire replace switch,if you have power remove tail light bulbs and check for power in side socket.
118 views
Usually answered in minutes!
×