How do you remove the headlight assembly on 1995 ford f250?

SOURCE: Headlight lens removal

Open hood and look at top back of the assembly and you will see 2 clips. Pull them up and remove,then release the lower clip and pull assembly out.

SOURCE: Mercury Villager headlight assembly diagaram for removal

This is easy. Lift the lid open. Look at the back of the sealed beam and you will see a clip and an o ring. Pull the clip up and pull wires back toward the driver's seat. Unscrew the o ring and firmly pull the bulb out toward the driver again. Note the 3 tabs on the bulb seat and realign the new bulb with those tab ( 2 bottom, 1 top). Replace with #9007 bulbs..do them both.

Wayne Fellows

• 262 Answers
• Posted on Sep 02, 2010

SOURCE: 1995 ford f250 headlight assembly how to remove.it

REMOVAL AND INSTALLATION Headlamp Assembly Removal

1. Remove radiator air deflector from radiator support.
   

1. Remove two screws and two nuts retaining headlamp door (13064).
   

1. Pull headlamp door from vehicle. Remove three bulbs and sockets.
   

1. Disconnect engine control sensor wiring (12A581) from headlamp bulb (13007).
   

1. Remove two retainers attaching upper two attachments of headlamp (13008).
   

1. Turn horizontal headlamp adjusting screw (13032) completely out of the adjusting nut.
   

1. Pull headlamp from vehicle.
   

1. Follow removal procedures in reverse order.
   

1. Tighten screws to 1.4-2.3 Nm (13-20 lb-in). Tighten nuts to 4-7 Nm (36-61 lb-in).
   

SOURCE: I cant figure out how

If you looke at the back side were it looks like the bolt in the should be a little tab sticking out at 90 degrees those a retainer clips pull up and the headlight should release.