Sorry, there are no current prices on replacing leather seats for a 1999 Mazda. However, check out the web site and you may find a dealer who will replace the leather. www.mazdapartscenter.com if you
need an Car Key Programmer, click here:Car Key Programmer
SOURCE: 1994 Cadillac Deville front seat recliner broken
Not a very common problem. You can get either the part from the dealer, or the seat from the junk yard. It will have the piece you need to correct the issue.
SOURCE: 1999 Cadillac Deville Driver side power seat not working
No fuse.These seats are protected with relays and a seat module.The module is under the drivers seat.There are 3 connectors and it would be hard to check all these wires for power to the motors.First look under the seat and make sure none of the connectors came apart under the seat by something that might have been left or rolled under it.The 2 main ones you can check are the connector 2 terminal C and connector 3 terminal A.C is a black wire which is ground and A is a red wire which is the feed power wire.Connector 2 is green and 3 is black.If the ground and power wires are good then you could have a bad drivers seat module.What I would do is go to the salvage yard and find a used module to try.Good luck.
Testimonial: "Thanks for your assistance. Great information"
SOURCE: 1992 cadillac deville, driver's side seat belt
OK, I had the same problem with my 1990 Cadillac Deville. Had to go to a junk yard where they gave me the entire bolted on assembly. I got a 3/8" impact wrench and unbolted the belt buckle from the frame, and did the same to the one on the assembly they gave me. After that my buckle worked great. The color even matched the old one.
SOURCE: replace the license plate light bulb-'99 cad
Hello,
Please follow the instructions below carefully to change the bulbs in the licence plate of your cad deville;
1.All you have to do is put a flat blade screw driver on the right side of the bulb housing and gently push to the left. This will release the catch holding it in and it will drop out and down on the end of its wiring connector.
2.1/4 turn the bulb and remove. Replace the bulb and just put the housing back into the opening left side first, then just push up on the right side till you hear a click. Takes about 1 min per light. Works for all Deville types from 99-08
Good luck.
SOURCE: Why would the drivers seat
This is due to a bad switch or seatmotor, the seat uses diffrent motors to control the seat so seat can still tilt but not move back or forward, this best way to know which ic the problem is with a testlight, hold the switch to move forward or back and test for power and a ground to that motor, if theres power and ground then motor is bad, if theres no power then switch is bad, hope this helps.
653 views
Usually answered in minutes!
Electric Seat?Power to motor? (Test light)
1996 deville clunking behind drivers seat when hittng hole
what is code 135 on cad deville 2004
×