"Clanking" Noise When I Turn Left

Ball joint / steering joint or arm

Check front upper strut bearings.

May have a bad ball joint or CVC joint.

did the timing belt break

If you have a rubbing noise on the BRAKES then its most likely the pads worn out and touching the metal backing plate ,other wise it could be the wheel bearing worn or coming loose but the CV Joint if worn will make a clanking noise when turned on full lock either Left or Right.
So jack it up at the front and check the wheel bearings and turn the wheel to see if the noise is there as it will be a metal to metal noise ,but if pads are good then it will just be a soft rubbing noise.

could be the c/v axle, the ball jount. or the powerstreering belt is loose

You may have a worn out CV joint and a bad wheel hub. Have them both inspected and replace any worn parts. A bad CV joint will cause your to be stranded out some where is it fails and a bad wheel hub will cause your wheel to fly off it it fails. best place to have the work done would be a transmission shop, since there always working on drive line components. Good luck and call around for the best price.

Pull the engine accessory drive belt off and check the pulley bearing and the nose of the water pump and AC compressor for play, this may be the AC compressor pulley bearing or the water pump pulley bearing

CV joints yes look at the rubber boots for damage. You can get a replacement boot but if you do remove all the old grease to remove any dirt that is cousing your problem.

Please clarify!