SOURCE: the driver side back door is closed and i cant get it opened
you may want to have someone put their feet against the door and push while you lift the handle
All of these functions are controlled by a central electronic module referred to as the BCM (body control module), you must have the dealer scan this module and run it through an active test to see what is wrong, it may be a defective BCM causing this, but that needs to be programmed and is not a plug and play part.
SOURCE: Power windows will not work gauges speedo and tach
Check the dash for proper grounding and also check the door harness where it passes through the boot for breaks or shorting. The door may be completing the body ground through the latch.
SOURCE: Driver side power window buttons are not working.
Try replacing your switch.I got 2000 dodge that did the same thing and it was the switch.
Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Control any distant PC remotely. Test the Software now for Free!
www.TeamViewer.com/Remote_Control
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
494 views
Usually answered in minutes!
×