SOURCE: 2002 GMC Sierra 1500 rear brakes
Hi joelalthomas, if they replaced your brakes and you never even made it home they had better warranty the work and as for the "it was a common problem on 2002-2004 trucks" well check for Chevy recalls as this is a safety issue that would have been corrected at no expense to the vehicle owner, do a little more research my friend and let me know what happens, I will check around a little as well in the meantime I would find a new garage.Do not pay any more as you said your brakes worked fine until they worked on it good luck to you As for your 4x4 did you look at the left side when you did the right side? and were they bled off properly? you can visually check to see if the calipers are functioning
SOURCE: 2002 GMC Sierra 1500 rear brakes
The first problem that I see is.....
You got screwed, the rear brake shoes and the parking brake shoes and the same thing. The parking brake uses your back brake pads to set the brake.
Sorry man
SOURCE: 2003 GMC Sierra 1500 tailgate will not lock shut.
Check to see if the mechanizm is siezed behind the handle that lifts up. this is quite common , also check the latches at the ends of the tailgate to see if they are not stuck in the unlatched position ,If they are retracted and won't come back out this confirms a sticky or siezed Mechanism.. WD 40 or someting simular to free up everything works well. good luck
SOURCE: 2005 GMC Sierra 1500 - heater blows, but only cold air
Check coolant level. Check for heat at the heater hose going from water pump to heater core at firewall. Check to see that cable is moving coolant control valve from the closed to open position. Low mileage so it shouldn't be plugged heater core.
Testimonial: "You were absolutely correct. Low coolant level. Put in some 50/50 and we're nice and toasty now, but need to find out why coolant was so low. Thanks."
SOURCE: 1990 GMC Sierra 1500 pickup. Windshield wipers, Cruise Control
May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.
344 views
Usually answered in minutes!
×