I have an intelligent key. When i press the brake pedal to start the car the brake pedal feels tight and hard to push. When i push the start button the light comes on on the dash for the key. The battery is new in the intelligent key.
I unfortunately don't have a solution, but I'm having the exact same problem with my 2010 Cube.
SOURCE: i put a new battery in my 1990 maxima car wont start
try putting the key in the trunck and poping it it should reset the security
SOURCE: Nissan Sylphy Intelligent-Car Remote Controller Not Working
Hi,
Some key fobs are coded and if this is so you will need to take it to your Nissan dealer with all details of the vehicle i.e. Log book/title and vin number proof of ownership. There may be a small charge for this.
Good Luck!
Press the Blue Button please when satisfied with my FREE effort, Thank You!
Paul 'W' U.K.
SOURCE: 2005 xterra will not start
try this ...turn on lights and try to start...do the lights dim?.... yes? replace starter,,,,and be sure to clean/ tighten ground from battery also
SOURCE: my brakes are locking up on all four wheels on my 04 sentra.
Your brake light switch is adjusted in all the way and is pressing on the brake pedal. This causes the brake to be slightly applied. As you drive the vehicle the brake fluid heats up and expands, the brakes will apply more and more until you see the smoke. Bottom line: your brakes are always applied at the master cylinder because something(usually the brake light switch) is out of adjustment.
SOURCE: 05 Altima, car will not go when the accelerator is pressed
Have you had the battery and alternator checked yet? If not, you should. It may be that the control units connected to the CAN aren't being supplied the correct voltage(too low) to operate properly.
CAN COMMUNICATION
System Description
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.
Component Parts and Harness Connector Location
1. ABS actuator and electric unit (control
unit) E125 (with ABS)
2. IPDM E/R E121
3. Display control unit M95 (with NAVI)
4. BCM M18 5. Combination meter M24
6. Data link connector M22
7. TCM F56 (with A/T) 8. ECM F54
1,451 views
Usually answered in minutes!
engine will not start, key light lit up in dash, brake pedal hard
I had exact same problem, car battery and FOB battery are fine. AAA came and had to tow it to Nissan dealership. They replaced bad steering wheel lock on my 2010 Cube with 26,500 miles. Ended up costing me 800 bucks with tow, labor and parts. I've read other complaints regarding this in Cubes and other Nissan vehicles. Nissan should pay for this as it is obviously faulty.!!!!
×