I have a 2000 Saturn SL2. Just had the ignition replaced because key was stuck. Mechanic said it was hard to get out. Following that repair, it will only run for ~2 secs when started, then it dies. Now I'm told I need a new body control module. Can replacing the ignition and ignition housing damage the BCM? Is there a wire that may have been cut during the ignition repair, or anything else damaged in the steering column that could cause the BCM failure?
The problem is not the bcm. the passlock security sensor is in the cylinder and housing, if the cyl and or housing was replaced the system must be relearned. if you replace the bcm you still need to relearn the system or it still will not start.
How do I remove and clean an EGR valve for a 2000 Saturn SL1?
I'm told that I need to replace it's ignition control module and two associated coils as well. Is this easy to do? I'm not sure what the coils are but the control module is way less than half online to buy direct than through my mechanic (300+).
2,097 views
Usually answered in minutes!
I have the same problem meaning, my key is stuck also and I was told that I need to replace my ignition switch also but I don't want to create a bigger problem.
Need to know the process for changing the icmodule on l
×