I owned a 93 GC 4x4 and I did replace my front axles with CV joint axles. The new axles came with CV joints, with a rubber boot and all so yes you can.
SOURCE: 95 jeep grand charokee laredo hard to start,
can u pls tell me the price of grand charokee 2011
SOURCE: 1993 Jeep Wrangler - Front Axel U joint, why no C clips?
The factory u-joints use plastic injection for retainers so when it comes time to replace the factory u-joint use a torch to heat the u-joint cups and you will see a melted plastic worm come out the side of the drive shaft, now you can drive out the old joint.
The replacement joint will use inner c-clips.
SOURCE: How do you keep the front engine hood up?
does it have shocks or springs??? if shocks you have to buy new ones
SOURCE: 97 jeep. Removing front wheel bearing
Most times you can squirt some wd40 on the ends of the axle spline, then put the axle nut on backwards so the castellated side is towards the bearing hub and run it onto the threads till the axle and nut are flush. (So you don't damage the threads or mushroom the end of the axle.) Once you have done that you can give it a really hard shot with a decent sledge hammer (two lb or heavier) striking it as squarely as possible. I have never had one refuse to come apart when I do this!!!
453 views
Usually answered in minutes!
×