1995 Mercury Sable Logo
Anonymous Posted on Sep 08, 2012

Where is my throttle position sensor located on my 1995 mercury sable 3.8l

2 Answers

Ed Warden

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Expert 218 Answers
  • Posted on Sep 09, 2012
Ed Warden
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Mar 09, 2009
Answers
218
Questions
0
Helped
151807
Points
713

The Throttle Position Sensor is located at the top center rear of the engine, on the throttle body.
Here is a diagram showing where the TPS is located on this vehicle.
Hope this helps...

where is my throttle position sensor located on my - 9_9_2012_1_02_38_am.gif

Testimonial: "Basee!"

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Expert 60 Answers
  • Posted on Sep 12, 2012
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: May 17, 2012
Answers
60
Questions
2
Helped
23351
Points
168

Follow your breather to the throatl find the linkage where cables go to your ecelarator just to the left of that and below that is a small electrical sensor with two bolts in it with a wiring harness atched to it !

Ad

5 Related Answers

Anonymous

  • 958 Answers
  • Posted on Oct 04, 2008

SOURCE: Where is the starter located on a 1993 mercury sable engine

trace the big cable that came from the positive terminal of your battery. at it's end is the starter.

or if it passes trough a big relay, then there is another big cable from that relay that would go down to the side of the engine, either left or right, that would be the starter.

tnx 4 using fixya,

drcool

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Nov 12, 2008

SOURCE: DPFE Sensor with codes PO401 And PO402

The DPFE is located near the EGR valve, it has 2 very thick silicone rubber hoses connected to it that come off the exhaust. It is rectangular and about 1/2 the size of a pack of smokes

fordexpert

  • 5692 Answers
  • Posted on Aug 18, 2009

SOURCE: 05 Mercury Montego Throttle control/sensor

Try a salvage yard for the part. As soon as your new car left the lot it became a used car. Used cars run on used parts.
If the old part is a recall they will upgrade you regardless which part is on your car.
Check the internet and enter your part# in the search box of the Browser. You may get lucky for a new part.

Anonymous

  • 163 Answers
  • Posted on Mar 28, 2010

SOURCE: fuel pump relay location on 98 mercury sable

its under the hood on driver side what the problem not starting check the trunk area for the fuel cut off switch poss bad or tripped did u get hit or someone bump ur car

johnjohn2

Johnny Brown

  • 5763 Answers
  • Posted on Nov 07, 2010

SOURCE: EGR DP sensor location on a 1999 mercury sable

This sensor delta pressure feedback sensor for the egr is located on the top right side of the intake manifold, heres a diagram that will also help in locating this sensor, hope this is helpful. johnjohn2_12.gif

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

Were is the crankshaft position sensor located on 95 ford 3.0 sable

See the attached image. It may not be exact but should get you in the ballpark.
25282268-cqcheelhvatlzkmvt50ynpkc-1-0.jpg
0helpful
1answer

1995 mercury sable no fire from ignition coil

MAke sure its in park( just move it though the gear shifts) sometimes the neutral switch gets sloppy age/usage/transmission swap etc. Check for voltage at the coil positive terminal when the ignition key is on. YES there is voltage, the problem is on the trigger side of the coil (pickup, crank sensor, ignition module or primary wiring circuit). If there is NO voltage at the coil, the problem is on the supply side (the ignition switch or ignition wiring circuit). Check Relays and Fuses.
1helpful
1answer

My 1995 mercury sable won't idle

Your TPS (Throttle positioning sensor) sensor needs to be checked and more than likly replaced, hope this helps.
0helpful
1answer

My 99 mercury sable is running very poorly it cuts off at stoplights and ay other times it reves to 3000 rpms without my foot touching the gas. the car also drives through town at 45 miles an hour wihout...

on the back of the engine are some vacuum lines that get damaged.either that or the throttle position sensor is not working properly.it is located on the throttle body.
2helpful
2answers

Where is the Air Flow Meter/Mass Air Sensor on a 1993 Mercury Sable and it is easy to replace?

The MAF or mass air flow sensor is located on a tube connecting the air filter box to the throttle body. Just unplug the connector and unscrew the sensor then pull it out.
1helpful
1answer

The computer is reading 1120 my manual only goes to 995 what is 1120?

P1120Throttle Position Sensor out of range, This sensor is about 1 inch in size, and is located on the throttle body
0helpful
1answer

No oil pressure, camshaft position sensor error,

Yes, the sensor is in small housing the goes in the hole where the distributor used to go. That also drives the oil pump so don't drive it you'll ruin the engine. It's located down under the throttle body, near transmission end of the engine.
1helpful
1answer

Need to know what fires coil 1995 mercury sable both wires to coil have power when key is turned on car cranks no spark from coil new coil what gives the coil extra power to fire

what engine? 3.0L 2 Valve? 4 Valve?
3.4L SHO engine?

The PCM (engine computer) fires the coils, but it is never the cause of a problem. I suspect it is the crankshaft position sensor on the front of the engine by the crank pulley. easy to change.

Crankshaft Position Sensor The crankshaft position sensor (CKP sensor) (6C315) is a variable reluctance sensor triggered by a 36-minus-1 tooth trigger wheel located on the crankshaft pulley and damper. The signal generated from the crankshaft position sensor is called the crankshaft position (CKP) signal, which provides base timing and crankshaft speed (rpm) information to the ignition control module (ICM) (12K072). Base timing is set at 10±2 degrees before top dead center (BTDC) AND IS NOT ADJUSTABLE. The powertrain control module (PCM) (12A650) will use this information with the spark advance information to determine ignition coil (12029) turn on or turn off time.
2helpful
1answer

Location of the camshaft position sensor in a 2004 mercury sable

it is located on top of the engine right below the air inlet tube at the base of the intake it is a black sensor on top of a silver housing where the distributor would normally be
Not finding what you are looking for?

2,692 views

Ask a Question

Usually answered in minutes!

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...