We just replaced the computer now the jeep will noy go in to overdrive
Was the computer for that exact year and model ? computers have to be matched to that same model to run the same transmission as in the vehicle example 1999 ford crown vic trans.put in a 2000 crown vic even though the trans. is the same the ccomputer reads trans. is built for 1999 cause of the program in the comp.
SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee
One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.
SOURCE: 94 jeep grand cherokee will not shift into overdrive
My 97 Jeep Grand Cherokee was doing the same thing. I changed the TPS ( Throttle Position Sensor) Now it is great goes into overdrive fine. It is really easy to change.
SOURCE: window motor replace 2001 jeep grand cherokee
You need to remove all the skrews from the door. Normaly there is one in the handle of the door, one behind the in door lach handel and one under the bump out for the arm rest on the door. Than you need to take a flat head skrew driver slowly priying the panel off. There are plastic clips on the backside of the panel it is ok if you brake a few.
SOURCE: replace fuel filter on 1997 jeep grand cherokee
If you have the V8 engine, the filter is actually part of the fuel pump. WHICH IS IN THE TANK
SOURCE: shift indicator light 1999 Jeep Grand Cherokee
There are two parts to it, a voltage resistor, and the EL panel itself.
You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.
There are a total of 6 flat screws, and 3 self tapping screws you have removed.
Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.
Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.
Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.
Re-install everything in the opposite order.
327 views
Usually answered in minutes!
×