Tail,tag,dash lights not working on a 92 cougar

Thread: Help! No Dash lights, Tail lights or Tag lights - The Ford ...

forums.focaljet.com/.../510540-Help!-No-Dash-lights-Tail-lights-or-Tag-...
May 2, 2006 - 11 posts I have a 2002 Focus SE 4dr. I don't have any Dash lights,Tail lights or Tag lights. Everything else is working ... Join Date: Oct 2005; Posts: 838 ...

Look for a bad fuse.

Maybe you didn't reconnect the ground for those lights. Check for tail light fuse or IP lights fuse. You may have to get a test light or voltmeter, and start looking for where power is lost. Start at the rear light sockets, and work back to the front, to the park light switch.

The dash lights take a feed from the tail circiut,may be a corroded connector,pinched wire somewhere.The blower problem likely not related,maybe bad blower motor or resistor.

Are your dash lights out also? The tail and dash lights are wired on the same circuit and share the same fuse.If your dash lights are working then check the tail light bulbs, I know that it is rare but I have been fooled more than once by both bulbs being blown.

it could problem with main connector of headlight or combi switch, pls clean it and re fix it.

If you don't have a manual, just get a test light, and ground it to your door hinge. At the back of every fuse, you will see part of the metal filament showing through. Touch your test light to each side of the fuse. You should have power to both sides of every fuse (when your key is on). If no voltage on one side, the fuse is burnt.

dash and tail sre tied together, so chk tail light fuse.

YOU MAY NEED A LIGHT FAILURE SENSOR WHICH IS LOCATED IN THE TRUNK ON THE DRIVERS SIDE

there are a few fuses under the hood be sure to check fuses again at dash they could look good but not be and if one was blown it could have blown as soon as you turned them on again that would indicate a short. it could be the switch also if it is the pull type try pulling it slowly to see if they come on and turning it like to dim the dash lights. if that makes them come on you need a new switch sometimes it will work sometimes not