Where is the wiper speed control module located on a 1994 ford ranger xlt supercab 4.0 engine

Marvin

• 85242 Answers
• Posted on Apr 25, 2009

SOURCE: 1994 ford ranger intermittent wiper

replace the wiper speed control module.

SOURCE: location of ignition control module

It does not have an ignition control module.
The electronic ignition (EI) for the 4.0L engine consists of the following components:
Crankshaft position sensor (CKP sensor) and 36 minus 1 tooth trigger wheel.
Ignition coil .
powertrain control module (PCM) .
Related wiring.
The PCM controls the firing of the coil based on the signal from the crankshaft position sensor.
The crankshaft position sensor (CKP sensor) is a variable reluctance-type sensor, triggered by a 36 minus 1 tooth trigger wheel configuration machined into the rear of the crankshaft vibration damper. The signal generated by this CKP sensor is called a CKP signal. The CKP signal provides the base timing and rpm information to the powertrain control module (PCM). Base timing is set at 10 degrees BTDC and is not adjustable.
If vehicle has no spark then turn key to on position,check engine light should come on.As you start cranking engine it should go out while cranking after about 10 secs. it should come back on(while cranking). If it come on then the PCM sees the signal,if it does not then PCM is not seeing it and this is your problem,either the CKP sensor or the wiring to it.

SOURCE: where is the ignition module control located on 1996 ranger 2.3 e

It does not have an ignition control module. The PCM (powertrain control module) fires the coil pack based on signal it recieves from the crankshaft position sensor and the camshaft position sensor.

SOURCE: scanner codes 335, 543 on 1994 ford ranger 2.3L

335 crank shaft sensor,543 (Mem) Fuel pump relay or battery power feed was open.PCM is located under the instrument panel, is the brain of the EEC system

SOURCE: where is the obd connector on a 1994 ford ranger 4

It is under the hood on the drivers side