The brakes go almost to the floor with abs light on dash. Whenever started the strong odor of gas or something is there.
SOURCE: ABS BRAKE LIGHT ON IN MY SUBURBAN/GMC TRUCK
Try diconnecting the battery for a minute or so, then reconnect it. the computer should reset itself, and hopefully the light will go out.
SOURCE: dash lights on abs and brake
this is a abs pump problem. common on these circuits get "unsoldered" from vibration. if you feel like you can solder conections its a good couple hour job and sometimes things get burned out from voltage spikes. good luck jimmy rate as fixya thanx
SOURCE: ABS light on after replacing the front and rear brake pads .
u will need to check the wheel speed sensors behind the brake rotors to see if they got damaged or disconnected during the brake job, as long as the ABS light is on the Anti-lock brake system is disabled, regular braking without the need of ABS will feel fine.
SOURCE: ABS/Brake Light on GMC Envoy Dash
Hi, I had the same problem on my Voy 2005 and after I checked the ABS sensors and repaired EBCM ground under driver's door it was the ignition swich that I got from autowreckers for $50.00 and it fix the problem. I had this swich already replaced under warranty.
Job takes 30 min and is easy dealer wants aprox $250.00 to do it
SOURCE: 2001 Jimmy ABS and brakes lights came on
I hate to say it, but the abs control module might have died on you. Thats the boxy looking thing under the hood that has a lot of brake lines and wire connectors going into it. I have seen this happen before and it ended up being one of the speed sensors on the wheels but usually its the module. Take the truck somewhere to get the light scanned, and that will give you a better idea of what it is.
249 views
Usually answered in minutes!
Gas and brake fluid smell very diffrent, please decide which it is.
gas
×