In the fuse block, under the dashboard, there is a little canister type of relay, The manual says that it is a time delay relay. But everybody that I ask about it dont seem to know the purpose of it. I am asking this because I am having problems starting my truck and this sensor gets super hot when I am in the process of trying to start it. I replaced once and there was no change.
SOURCE: 1995 Dodge Dakota Pick up
go to Didgeforums.com.
I had a similiar problem, found the solution there. It was the wiring harnes on the drivers side under the hood, just above the wheel well. there are a cluster of wires in a bundle. I unpacked the bundle carefuly and sure enough the were two or three wires all coroded, had wite powder from corosion. repaired the connections and bingo. I posted details at dodgeforums.com. browse around there. I posted pictures as well. this is a common problem.
SOURCE: 91 Dodge ram 50 ignition problem, rough idle in drive,dies when braking
my ram 50 starts just like any other vehicle, (no light switch pulling whatso ever), it sounds like somebody haas rewired something wrong or you have a loose connection and when you hit a large enough bump it cuts your power. Start it up and find a speed bump somewhere and drive over it enough to give your truck a jolt and see if it dies.
SOURCE: 1995 dodge dakota 2wd 3.9 no spark to plugs,or coil,orfuelpump
First of all let's explain how the spark gets to the plugs. There is a crankshaft position sensor and a cam sensor. They are what determines when to fire the coils and injectors. The crank sensor is located on the passenger side on top of the bellhousing, the cam sensor is the pickup plate in the distributor. As the engin turns the send refernece pulses to the computer which grounds and ungrounds the ignition coil causing it to discharge and send voltager from the secondary coil wire to the center tower in the distributor cap. The rotor button recieves the voltage and distributes it to the 6 towers (1 for each cylinder) If you say you're getting spark from the rotor that tells me the primary side of the ignition system is working, and the secondary side is working into the distributor cap. I'd check for spark out of the plug wires at the plugs. Pull a wire and insert a #2 phillips screwdriver into it, hol the shaft of the screwdriver aprox 1/8"(no more) from the exaust manifold and observe the spark as someone turns over the engine. You should see a nice blue spark. If theres spark, spray a little gum cutter in the throttle body an crank it, if it fires you have a fuel problem. Install a fuel pressure gauge on the schrader valve on the fuel rail and observe it as you crank it. If theres no fuel pressure maks sure there's fuel in the tank, if so climb underneath and beat on the bottom of the tank with a rubber hammer, the pump may be going bad, sometimes you can jar them and make them run.
SOURCE: 2007 dodge Ram 1500 hemi fuel cap sensor comes on
I just had the same problem, new cap, deleted the codes with a obd... took it to the dealership...
its the EGR valve that was bad on my truck 2007 dodge ram 45000 miles...
i get it back on friday, its a simple part 1 wire harness and 2 bolts and gasket.
249 views
Usually answered in minutes!
×