Cars & Trucks Logo

Related Topics:

Anonymous Posted on Aug 20, 2012

90 olds silhouette engine code 12 and 32 - Silhouette Oldsmobile Cars & Trucks

1 Answer

ZJ Limited

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Oldsmobile Master 17,989 Answers
  • Posted on Aug 21, 2012
ZJ Limited
Oldsmobile Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jul 15, 2008
Answers
17989
Questions
0
Helped
14457905
Points
60858

Hi there:
Code 12 - Memory standby power recently lost - Possible Causes
Battery or power line recently disconnected - This code is normal if the electrical system has been worked on or the battery has recently been disconnected. It will be removed after 15 ignition switch on/off cycles.


Low system voltage, bad battery or battery terminals - If the system recently had a power drop (due to a dead battery or bad alternator), this code will appear. If the battery terminals are bad and the engine was jumped, this code will appear. See the Diagnosing Your Charging System page for more information.


Bad connection or wiring - Check the wiring and connections between the battery, power module, and logic module (or SMEC). Check all fusible links and power connectors to the battery. Clean and regrease any corroded connectors with dielectric grease and repair any shorts.




Code 32 - Logic module did not see a change in air/fuel ratio when EGR circuit was activated - Possible Causes
EGR valve stuck open or closed - If the vehicle fails emmisions, then the valve may be shut. If the enigne runs poorly at low rpm or at idle, the valve may be stuck open. It may be the valve or the transducer valve. Test the transducer valve vacuum output. At idle, the transducer valve vacuum should be mostly bled, and there should be very little, if any vacuum at the output. When the engine is revved, the vacuum should increase. If the transducer is functioning properly, replace the EGR valve.


Bad EGR solenoid or Canister purge/EGR solenoid - The solenoid is located in the right, front fender next to one to three other solenoids. See the Understanding Solenoids page for information about how to test and repair solenoids.


Bad connection or wiring - Check the wiring and connections between the solenoid and the logic module (or SMEC). Clean and regrease any corroded connectors with dielectric grease and repair any shorts.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.


Thank you for using FixYa, have a nice day.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
1helpful
2answers

1998 olds silhouette hard to start in cold weather

I suspect your car doesn't have a choke if it is EFI.

I'd suspect a faulty coolant temp sensor unit, which is not telling the ECU that the engine is cold.

Some EFI cars have an extra injector called a cold start injector. If fitted this could be faulty.

In both the above cases there may be an ECU trouble code you can read out. In the US Autozone will do this for you.

In the old days the classic cause of hard starting was always faulty engine timing. If your car has a timing belt and it is worn, it may have jumped a tooth or 2., but this is uncommon.
1helpful
1answer

How to reset check engine light on 2000 olds silhouette

Use a code reader or disconnect the battery NEGATIVE (not the positive!) cable for 5 min's. The best way is the code reader as you will loose all learned programming in the engine control computer and this can cause idle problems. Autozone will do this for you free.
0helpful
1answer

Torque specs 2003 olds silhouette rocker arm 3.400

Here is a suggested updated torque spec for this engine's rocker arm bolts;
Rocker arms
Step one: Torque to 11 ft lbs then tighten an additional 90 degrees of bolt head rotation. Some guys don't fuss with the torque specs and just get them good and tight. Either way, be careful, as the heads are aluminum. You do not want to over tighten these bolts
0helpful
1answer

98 olds silhouette started sputtering computer read a code for oxygen sensor replaced both sensors and fuel filter but still running eratic some time dont want to run at all what are most commin problems...

First take EGR Valve off and clean it with a wire brush and a non-chlronated brake cleaner.If it still runs bad check your fuel pressure it should be 41-47 psi with key on engine off if not within specs replace fuel pump.
1helpful
1answer

My 2002 olds silhouette had a fault code for bank 1 oxygen sensor #2.So I changed the oxygen after the converter and the fault code is still there.I did un-hook the battery to clear the code.

Bank 1 sensors are all the o2 sensors before the converter. Bank 2 sensors are all after the converter.On bank 1 there is 1 for each side of the exhaust manifolds. Bank 1 sensor 1 is on the side ot the engine that #1 cylinder is on. Bank 1 sensor 2 is on the other side. On front wheel drive GM vehicles sensor 1 is in front,2 is in back, but stiil in front of catalytic converter.
2helpful
2answers

How do I reset the service engine soon light on 2001 Olds Silhouette

A diagnostic scanner that reads OBD1 (the system by which your vehicle processes trouble codes) will be required, many parts stores do this a s a free service. Check with them to see if they charge. Remember though, when they read the car and turn the light off that in order for the light to stay off, the problem must be fixed. Even if it was a one time fluke of a problem, get the code that their scanner gives them so that you know what the issue is.
0helpful
3answers

Service engine soon light is on .

get a code # from code scanner and let me know and will assist further if can. autozone will scan for free.
Not finding what you are looking for?

148 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...