SOURCE: Gas gauge not working
Hi,
This sounds like the sender unit in the fuel tank is worn or possibly a corroded/ bad earth from the unit itself.
There should be an inspection plate above the fuel tank removal of this should reveal the sender unit and connections, if not can you see on top of it? make sure all connections are clean and not gunged up with corrosion. Try spraying Wd40 or similar around the area whilst wiggling the plugs/wires.
Good Luck, Please press the Blue Button to appraise my FREE! Effort.
Thank You!
Paul 'W' U.K.
SOURCE: Instrument cluster not showing odometer and
It could be the voltage regulator for your instrument cluster is the problem.
SOURCE: 2000 Taurus fuel gauge does not work. It goes
Is this a flex fuel taurus
Testimonial: "I had no idea the module existed! I will give it a try. Thank You! Ken"
SOURCE: lost power andquit. wont start
2 possible problems here. remember to always look at the inexpensive first.
That would be the ignition control module,which is held on by 2 screws beneath the distributor cap. the dielectric grease used in mounting drys out and causes it to over heat and burn out. cost about 35 bucks...10 mins. to install.
that is what i think your issue is...as fords from88-92 are notorious for it.
second possibility is that you have a bad ECM...and though takes 10 mins to install will set you back aboy 125 bucks.
217 views
Usually answered in minutes!
×