Pulled the hood relaease in the cab and the cable just kept pulling
SOURCE: inop hood latch 1985 corvette
In the windshield wiper area on both sides of the car you will see a rubber plug about 1 inch in diameter. Use a flatblade screw driver (about 8-10 inches) and poke this plug out of its hole into the engine compartment (you can recover it later.) Insert your screwdriver through the hole until you find the release latch. Just push it until it releases.
SOURCE: 2001 chevy malibu hood won't open hatch stuck?
a trick to try and get it to open is to (this sounds bad i'm aware) smack the hood of your car where it would latch (center at edge near bumper)...if for whatever reason it has slipped it can cause the part that hooks to be applying too much pressure preventing it from loosening. may or may not work...would be better if you have another person to pull while you smack smack on the hood so as it goes down, hopefully it frees it up enough for the person pulling it to unlatch it the rest of the way.
SOURCE: hood release cable is frozen, how to unlatch hood?
if you can get a pry bar or a screwdiver under the hood and push on the mechanism that the cable pulls the hood will open.then you need to replace the cable.
SOURCE: emergency break cable broke on 2004 silverado
I had the same problem on my 2003. Open the driver door all the way. Get on your knees just outside the door. Follow the plastic tub that holds the parking brake release cable inside the truck. Start from the release lever and follow to the end of the tube. There will be a metal lever that the cable was attached to before it broke. You have to pull that lever with your hand to release the parking brake. Very Important!!!...Hold the parking brake activation pedal with your other hand when you release the brake. Let the pedal out slowly when you pull the metal release lever. The pedal will come back very fast and you could injure yourself if you are not careful. Good luck!
SOURCE: No hood release cable Chevy S10 truck
I have this same problem. You have to take a screw-driver (philips) and look between the hood and the grill and you will see the hood latch assembly. There will be a large gauge wire with a loop about the size of a large philips head screw-driver. This is the release. Take the screw-driver and push the wire towards the drivers side door and it will release.
Testimonial: "THanks, solution concise and tells me where to look and how to do it. Because I was looking to taking off my grill and not sure how to do that."
96 views
Usually answered in minutes!
×