On start the car if power steering is working then it remainns working when ever engine goes off .some time when engine start its power stering does not work it feels soo heavy and then few days it would not work what is the problem
SOURCE: dodge ram van e250 dies while driving
try changing the coil- sometimes they get hot and break down- once they cool off vehicle will start and run until they get hot again
SOURCE: The powered steering in my
check the power steering fluid if it is full then you would have to replace your power steering pump if not you might have a leak and if so get that fixed before you destroy your power steering pump.
SOURCE: when i turn the steering
It could be the pump, or you could also be low on power steering fluid. First off, check the level of the fluid and make sure it's adequate. Next, you can "burp" the power steering system easily, which will get rid of any air bubbles that could be in there. Easiest way is to jack the front end off the ground (both wheels), start the engine, take off the power steering fluid reservoir cap, and turn the wheel side to side as far as it'll go, several times. This circulates the fluid through the system and pushes any bubbles in there up to the reservoir, where they'll float up to the top and "burp" into the air.
If neither of those things works, you may have problems with the steering rack and pinion, or possibly with your suspension (check the tie rods, inner and outer, as well as the bushings in the various suspension pieces).
SOURCE: how do i bleed my power steering rack on subaru legacy rs turbo
A power steering dosent need bleeding. If you replaced it a week ago and was fine until now then it's not an air problem. Power steering fluid is pumped through the system even when the steering is not being used. Definatly not an airlock problem. Cheer's
SOURCE: how to reset peugeot 307 electro-power steering?
but did you buy it new? if yes you need to go to a peugeot dealer to have programmed, if not and broken you have to replace it if you want to be sure disconect the cable from power steering motor and you will find all full of oil ciao
394 views
Usually answered in minutes!
×