I'm getting enough spark I checked coils confused?
Bad fuel injectors. bad spark plugs - inspect and or replace -- bad spark plug wires - test ohms resistance of the spark plug wires with a multi meter (5 bucks at harbor freight) -- or simply replace the spark plug wires.
How was it you tested the coil and spark at the plugs?
I'd lean more towads faulty fuel injection, if you go to repai this, please be sure to add a quality fuel tank cleaner like lucas (the larger the bottle the less the cost per ounce - and works VERY well), You may also want to be sure to replace the fuel filter...
Best regards
Ck
SOURCE: mazda rustler 160i
Hi Gerrie1974-
WildBill49 here......Not knowing the specific year and version of your Mazda, I cannot give you a specific part at fault, but I can help you. I am assuming we're talking about an electronic distributor single coil ignition system
If the spark is weak directly out of the coil (with a known good coil hooked up with correect polarity), then the problem is in the spark trigger module... There is a variety of designs, but the basic components remain the same. This is the part of the ignition system that replaces the breaker points. It consists of two parts - a magnetic spark trigger sensor, and a spark signal amplifier/controller. these are sometimes combined into one ignition module.
Replace this module, and spark from the coil should be strong! If it is still weak, reverse the two wires to the coil.
Weak spark at the plug wire with the above good indicates distributor cap/rotor replacement time...
Gerrie, I hope this is what you are looking for, best of luck, and if you feel my advice worthy, please rate it!!!
Thanx-
-WB
SOURCE: hi i got a 2001
both coil at same time i dont think so key on do you have a check engine light on if not check all fuses let me know hope it a fixya thanks pierre
SOURCE: 2001 mazda protege will not start
well, with all that you have changed the only two possible things that are left PCM and the ECM....
Do you have an alarm system on this vehicle? If you purchased this car second hand it may have something that is inhibiting the engine from firing. From what you have told us here that would be where I would start looking.
I really hope this is helpfull
SOURCE: How do i plug in the spark plug coils? what order?
If it's the four cyl., the first coil pack bolts over the #2 spark plug. The #2 coil pack wire plugs into #3 spark plug. The number two coil pack bolts directly over the number four spark plug, and the #2 coil pack wire plugs into the #4 plug. The firing order is 1-4-2-3.
SOURCE: 2000 1.6
You may have fuel problem, change fuel filter to see if that helps, if not fuel pump may be going out.
614 views
Usually answered in minutes!
×