My 2001 Mercury Village keyless remote isn't working right. When I have the remote within 20 feet of the van, there is a semi-constant clicking noise, like the doors are trying to lock or unlock every 2-3 seconds. I have replaced the battery, with no change in it's behavior. No buttons appear to be jammed. It still locks and unlocks, but my van is constantly "clicking" the doors as I drive, and when I lock it somewhere, a lot of times it unlocks as soon as I start walking away.
Keyless Entry
The keyless entry system consists of the following:
The control module probably see's an input that shouldn't be there . lock Switch , door ajar etc... Don't think it has anything to do with the remote . Some part stores have a tester to see if signal from the remote is working . Or the dealer ! Take it an see if your remote is sending a signal without you pressing any buttons .
All doors can be locked at once by turning the door key lock switch to the locked position. An individual door can be unlocked by moving the door key lock switch to the unlocked position and turning it again within five seconds; all the doors (including the liftgate) will unlock.
The smart lock system is designed to keep the driver from locking his keys in the car. It will lock and then unlock all the doors if the smart entry control(SEC)/timer module detects the following conditions:
The panic feature has a duration of 30 seconds from the last time the PANIC button is pressed. When locking the doors from the remote transmitter, the horn chirp/lamp flash feature can be disabled or enabled by holding the LOCK and UNLOCK buttons for two seconds. The hazards will flash three times to confirm that the feature has be enabled or disabled.
If it is you need a new one .
SOURCE: 2005 chevy silverado 4 door rear locks
Sound like the door actuators are bad if you take it somewhere take it to a dealer auto body shop Its Cheaper
SOURCE: My 2door 2001 Honda Civic EX remote entry device
I used to install power locks on cars. Lets see if I can help...
Take off your door panel, find the small rod that is connected to the door lock itself (the part that actually shows if the door is locked or not) There should be an actuator of some sort connected to the small rod that pushes back and forth when you hit the lock button. This may have popped off or is loose/bent...
Or, There may be module inside the door that controls your locks either way, pop off your door panel and see what you got!
SOURCE: How do I reprogram my Keyless remote for Chevy malibu 2001
You need to take your car to a chevy dealer because they have the procedure for that, if tou call they wont help you by phone, they charge afee for that.
SOURCE: programming keyless remote
2003-04 Mazda 6 REMOTE PROGRAMMING
Step 1: Open drivers door and leave open.
Step 2: Lock and unlock the driver’s door using the power door lock switch on the door.
Step 3: Insert key into the ignition.
Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.
Step 5: Open and close the driver’s door 3 times. (Door should be left open after this step).
Step 6: ECU should respond by locking and unlocking the doors.
Step 7: Press any button on remote #1 twice. ECU responds by locking and unlocking the car doors.
Step 8: Press any button on remote #2 (etc.) twice. Each time the ECU will respond by locking & unlocking the doors.
Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done!
Good Luck.
SOURCE: 2004 Hyundai Sonata door lock functions inoperable.
you have a bad relay.. the 'lock' relay.
310 views
Usually answered in minutes!
×