SOURCE: rear shocks on a 1996 Mercury Grand Marquis
Raise car under frame then put jack under axle before removing the shock.
Can use locking pliers to hold the shaft from turning (may have to cut away dust boots). Top nuts are accessed and can be seen from the wheel wells or from the gap between the trunk and mount frame (can't see nut from this angle). Take care with fuel lines near the driver side nut.
Preventing shafts from turning on new shocks will be tough. Make sure you have a proper tool to fit top of shaft with enough room between top of shaft and trunk (gap decreases as the nut is tightened) so the tool can be removed.
SOURCE: where are the spark plugs located on a 2000 Mercury Grand Marquis
There are eight COPs (coil-on-plugs) to remove. Using a 7mm or 9/32" socket, remove each bolt securing each COP to the intake manifold on top of the engine. Remove all eight COPs, and the spark plugs are underneath. When replacing the spark plugs, use only the proper Ford/Motorcraft plugs, even if they cost twice as much as the aftermarket ones. You will avoid further headaches this way. Hope this helps.
SOURCE: how to replace starter +1993 Mercury Grand Marquis
disconnect battery,,jack car up,,put jack stand on frame,,take starter bolts out,(may not be easy),,take wires off starter,,hoped it helped,,
SOURCE: Need to change flasher relay in 1997 Mercury Grand
From the 1997 Mercury Grand Marquis
4.6L SFI 8cyl repair manual, the
Flasher is located behind left side of instrument panel. The turn signal and emergency flashers are attached to the interior fuse
panel. They are replaced in the same manner as the fuses and circuit
breakers.
Fig. 6: 1995-97 models interior fuse box locations (click for zoom)
Hope helps (remember rated this).
SOURCE: 1997 mercury grand Marquis driverside rear window
usually this means you need a new window regulator.
Section 01-11: Glass, Frames and Mechanisms
1997 Crown Victoria, Grand Marquis Workshop Manual
REMOVAL AND INSTALLATION
Window Regulator, Power
Front Door
Removal
Installation
Remove window regulator electric drive retaining screws through holes.
Remove two 1/4-inch rivets retaining lower bracket of front door power window regulator to inner panel. Use drift punch to knock out center pins for each rivet. Using a 1/4-inch diameter drill, drill out remainder of rivet.
182 views
Usually answered in minutes!
×