Switch is not working on the driver side
SOURCE: inside door handle 2004 sebring won't work
Hi
Most likely it's about an electrical problem - a switch or something ...
You can use the OBD 2 car diagnose system for this .
Is no need a computer ...
Good Luck
Shurehand
SOURCE: driver side power window stopped working
The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps
SOURCE: 2004 chrysler sebring.The driver side rear door electric window
you have a bad window regulator assembly
SOURCE: Driver Side Window not working in 2006 Sebring
cable that lifts it up could have broke you will need to remove door panel and take it out to have a look.Does it make a noise when you operate the switch
SOURCE: Driver-side window non-respondent (2003 4door Chrysler Sebring)
Your widow regulator is defective or the motor is defective. Remove door panel, using a punch, punch out the rivets, using a !/4 drill out the aluuminum plugs. Remove the regulator and inspect, if its not defective apply bearing grease when mechanism rolls up and down. Rivets must be replaced by 1/4 screws and nuts. Take motor apart, you will find three plastic plugs which have a tendency to disenegrate, replace these with ball bearings, pack the motor and I do mean pack it with wheel bearing grease. Reasemble.
204 views
Usually answered in minutes!
×