SOURCE: Instrument cluster on 1997 Jeep Wrangler...gauges
faulty cluster may have to replace it. try testing a junked unit if it works keep it.
SOURCE: 04 jeep cherokee...good battery but wont start
Could be the starter..
Try ---
( at the same time when turning the key to start )
give the starter a few whacks with a small hammer..
Takes 2 people..
If it turns - or turns slow - let me know..
SOURCE: 1999 Jeep Wrangler Dashboard
A poor connection at the self docking connections of the cluster. Remove the trim across the top of the intrument panel. Remove the screws at the top of the cluster trim and remove the trim. Remove the cluster screws and cluster. Apply dielectric grease to the self docking connectors of the cluster and reinstall. This should take care of it.
SOURCE: 91 Jeep wrangler New everything idles rough, no Power then dies
you check for miss how is compression
SOURCE: 2006 Jeep Wrangler won't start
First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.
Testimonial: "Will try! Thanks!"
334 views
Usually answered in minutes!
checked all grounds,fuses,etc.tried new ignition switch.
×