How to reset low tire presure light on a 2001 monte carlo

The low washer fluid light could be the sensor in the tank, and the low tire pressure could be a problem with the ABS system.
Check your owners manual on resetting the tire pressure light.

Turn the ignition on, do not start. Turn the light switch from off to "park lights" three times within five seconds.

If that doesn't work there is a more lengthy reset procedure that involves using the radio. I can get that info to you if needed or you can also find it in your owners manual.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

I am sure that you could make it work but you would loose your message center.

How to reset low tire pressure monitor, the reset is in radio controls. 1. Turn the ignition to ACC or ON and turn the radio off.
2. Press and hold the TUNE DISP button on the radio for at least five seconds until SETTINGS is displayed.
3. Press SEE PSCAN up or down arrow to scroll through the main menue.
4. Scroll until the TIRE MON appears on the display.
5. Press the 1 PREV or 2 NEXT button to enter the submenu. RESET will be displayed.
6. Press the TUNE DISP button to reset. A chime will be heard to verify the new setting and DONE will be displayed for one second.
7. Once the monitor has been reset, scroll until the EXIT appears on the display.
8. Press the TUNE DISP button to exit programming. A chime will be heard to verify exit.

Hope helps (remember to rate this).

the sensors are on each tire [its part of the valve stem] if warning light is on -one of tires need air also check pressure in the spare tire

Does not reset it self must be reset on radio

CHEVY IMPALA &
MONTE CARLO
On a Chevy Impala or Monte Carlo with indirect TPMS, a totally different reset procedure is required. You can use the light switch or radio to reset the system. With the light switch procedure, turn the ignition on (engine off), the turn the light switch from OFF to parking lamps three times within five seconds. With the radio technique, turn the ignition on (engine off). With the radio off, hold the DISP button until “SETTINGS” is displayed. Use the SEEK button to scroll down the menu until you see “TIRE MON.” Press the PREV or NEXT buttons until “RESET” is displayed. Then press the DISP button again. You should hear a chime and see “DONE” to indicate the TPMS system has been successfully reset. Use the SEEK button to scroll through the menu until “DONE” is shown, then press DISP once more to exit from the learn mode.

Though all of these TPMS applications use a similar technology and strategy to detect a low tire, there is no common reset procedure. GM is probably the worst, with 10 different reset procedures depending on the application. Toyota is probably the best, with only one simple reset procedure for all of their indirect TPMS systems (though a slightly different procedure is used on the Lexus models).

TPMS reset procedures may also be found in the vehicle owner’s manual (if it hasn’t been lost). Open the glove box and check the index in the owner’s manual for any TPMS information.

CHEVY IMPALA &
MONTE CARLO
On a Chevy Impala or Monte Carlo with indirect TPMS, a totally different reset procedure is required. You can use the light switch or radio to reset the system. With the light switch procedure, turn the ignition on (engine off), the turn the light switch from OFF to parking lamps three times within five seconds. With the radio technique, turn the ignition on (engine off). With the radio off, hold the DISP button until “SETTINGS” is displayed. Use the SEEK button to scroll down the menu until you see “TIRE MON.” Press the PREV or NEXT buttons until “RESET” is displayed. Then press the DISP button again. You should hear a chime and see “DONE” to indicate the TPMS system has been successfully reset. Use the SEEK button to scroll through the menu until “DONE” is shown, then press DISP once more to exit from the learn mode.

Good luck and this should work for you. They changed the reset procedure on the 2006 Impala.

I have a 2001 alero and the reset button is in the fuse panel. on the drivers side of the dash Push and hold the oil light will flash push it again the tire light will flash push and hold with the light flashing you should hear a series of beeps let go and that reset mine. Maybe yours is the same