SOURCE: driver door latch opens outside only
From the interior side, remove any screws for the armrest, door panel itself, remove window and door and handle if equipt. Remove door strap if present...pop loose the door panel trim or "door panel" and carefully remove without damaging the inside window weatherstripping.
SOURCE: 2000 mercury cougar front door panel removal
its very easy, takes maby 10min, there are hidden screws under the cougar symbols on the door, and under the black circles on the carpeted part of the door, they all just pop off, then there are a few on the ouside rim of the door 2 on each side i think, it might require a little jiggling but the car is pretty simple
SOURCE: 1995 Mercury Cougar Door Panel Removal
This nearly drove me crazy on our 1994 Cougar.
First
remove the electric switch cover(window and mirror controls). Just pops
out with a pry. Remove the harness attachments You will see a single
screw into the door holding a bracket between door pad and door frame.
Remove it.
Second, remove the door lamp plastic cover at the bottom
rear of the door. You will find a second screw in there on the upper
right corner. Remove it and you are ready. Pull the whole door pad
upward and it comes right off. No popem plastic clips or anything else.
Just 3 or 4 quarter circle retainers that pop over into the door when
you push the pad back down
SOURCE: how to remove the door panel on a 97 mercury cougar
you have to remove all of the screws on the inside panel and easily pry the door panel of the door give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish yoou the best of luck Michigan Man
SOURCE: how to remove the door panel on 1991 mercure
DOOR TRIM PANEL
1989-92 Models
(see Figure 8 - click over pic for zoom)
Fig. 8: Door trim panel-1989-92 models
To install:
Electric Window Motor
REMOVAL & INSTALLATION
WARNING
When drilling the holes, the glass must be in the up position. The
hole saw pilot must not extend more than1/4in.
(6mm) beyond the hole saw.
CAUTION
Secure the regulator in a vise and drill a5/16in.
(8mm) hole through the regulator sector gear and the plate. Install a1/4in.
(6mm) bolt and nut in the hole to prevent the sector gear from moving
when the motor and drive assembly is removed.
To install:
Hope helps (remember rated this).
239 views
Usually answered in minutes!
×