My subaru Impreza has lost its take of power and feels like its trembling when I drive and idle. I just had it serviced yesterday and replaced the fuel pump. What is wrong now?

SOURCE: 95 subaru impreza ;speedometer quit,engine light stays on

i had this problem with mine if your cable spins wen the car is moving its not the gear box end or the cable its the speed sensor in the speedo its self its very easy to fix you have to strip the speedo out of the case the sensor is only small and on the under side of the speedo the sensor is about 50 mm long and 10 mm wide change that and it should be ok
oh remember to reset your ecu

SOURCE: Knocking/juddering when taking off in first gear subaru impreza 1

Sounds like warped fly wheel.

SOURCE: '93 Subaru Impreza starting hesitance

TRY THE COOLANT TEMP SENSOR THAT ACTS AS A CHOCK .TELLING THE COMPUTER TO RICHEN OR LEAN THE FUEL BASED ON COOLANT TEMP

Brandon Johnson

• 253 Answers
• Posted on Aug 09, 2009

SOURCE: Power steering pump replacement for Subaru Outback

REMOVAL

1. Remove ground terminal from battery.
2. Remove pulley belt cover bracket.

1. Loosen lock bolt and slider bolt and remove power steering pump drive V-belt.
2. Disconnect connector from power steering pump switch.

1. Disconnect pipe C and suction hose from oil pump. CAUTION:

• Do not allow fluid from the hose end to come into contact with pulley belt.
• To prevent foreign matter from entering the hose and pipe, cover the open ends of them with a clean cloth.

1. Remove bolts which install power steering pump bracket.

1. Place oil pump bracket in a vise, remove two bolts from the front side of oil pump. CAUTION: Do not place oil pump bracket directly in the vise; use soft pads and hold oil pump lightly to protect the pump.

1. Remove socket from oil pump.
2. Remove bolt from the rear side of oil pump.

SOURCE: subaru impreza 1993 power steering leak

YOU CANT USE A REGULAR FUEL LINE ON POWER STEERING AS A HIGH PRESSURE HOSE.BECAUSE POWER STEERING PRESSURE IS 1000 PSI.YOU HAVE TO BUY THE POWER STEERING HIGH PRESSURE HOSE IT HAS NUMBER OF PLIES MATERIAL WEAVES TO MAKE IT STRONG.IT WAS MADE FOR POWER STEERING HIGH PRESSURE.YOU DONT HAVE A BLOCKAGE .THE HIGH PRESSURE HOSE JUST WORE OUT.REPLACE IT .IT SHOULD FIX THE PROBLEM.