SOURCE: I need to replace the fuel pump in my 1985 Chevy S10 Pickup.
EXACT PROCEDURE ! Please Rate Me Fairly for this!! Thank you And Good Luck !!
ELECTRIC PUMP
REMOVAL
INSTALLATION
MECHANICAL PUMP
REMOVAL and INSTALLATION
NOTE: To ease pump installation, rotate the camshaft so the camshaft eccentric is out of the way of the fuel pump rocker arm.
SOURCE: Chevy S10 Pickup Starter. Removed the two bolts
Just changed a starter in a 94 S10 4x4. The only way to remove the starter was to take the passenger side exhaust manifold off and bring the starter out that way. Installation the same in reverse. Hope this helps. Don
SOURCE: how do I remove drivers side door panel on 1998
i think there are screws around the door handle on the in side that need to be taken off the the rest just pop out
SOURCE: firing order for a 1999 chevy s10 pickup
I apologize for the late response...Due to the bad economic situation this site has had a substantial (+50%) increase in the number of questions being asked in the last four months.
I assume you have a 4.3L and not the 2.2L?
For the 4.3L:
Firing Order:
1-6-5-4-3-2
Cylinders:
6-----------5
4-----------3
2-----------1
(front of vehicle)
Distributor:
coil wire-->
-----6------->............<--------5-------
-----4------->............<--------1-------
-----2------->............<--------3-------
............(front of vehicle)
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!
SOURCE: Where is the turn signal flasher located on a 1998
take down the bottom panel below the steering column, which runs across the lower part of the dash, between the torx bolts and 7mm bolts it comes out and they are right below the radio area two silver flasher relays one is the hazards the other is the turn signals
344 views
Usually answered in minutes!
×