Cruse control not working 1898 Honda Accord EX

Many times a bad brake light switch will prevent the cruise from engaging. But your best bet is to get a shop manual and follow the step by step tests. Check with your local library to see if they have online access to a repair manual

check fuses and relays--have vehicle scanned most auto stores offer this service for free if theirs a pending fault cruise may not work -- possible switch malfunction-check brake lights including 3rd brake light relays and brake light switch -

I would check all fuses to see if any have blown.

well the cruse control has a cruse control module check that out but for the the turn signals and dash light if you already replaced the fuse maybe the lights burned out or you have a bad ground somewhere

I guess the cruse is'nt working? You first need to look it over to see if everythings hooked up. Did it work for you before or you haven't seen it work? The switch on the dash will light after turning it on but the car has to be running for it to turn on . Does the light light? if not check the fuses and see if thier any blown? To check to see that everything is hooked up find the throttle body, one cablr goes to the gas pedal and the other goes to the cruse, follow this cable to the cruse unit and see if that unit has all it's wires and hoses connected. To check you remove them and reconnect them looking into the plug or hose for dirt rust bent pins. The hoses can crack on the inside and leak which will make it not engage. Follow these hoses to where thier connected to the engine and the brake pedal as they can split and be disconnected there too. The brake pedal switch has to work too as does the clutch switch ( if it has a clutch) If the brake lights don't work niether will the cruse. The hi mount brake light if the bulbs fail the cruse won't work. The switch on the steering wheel can get disconnected too as it's on a clockspring circuit as the steering wheel has to turn. Is the airbag light on? if it is and the horn does'nt work either it's likly that the clockspring is broken, If the horn works and the airbag light cycles like it's suposed to then the clockspring is likly OK. The speedometer has to work too as the speed senser that works it also works the cruse.If everything is working your problem could be more seriuos but it's not likly as this unit is quite reliable.

no, no reset.

you have disconnected the cruse wire. look for the cruse servo,

Check the Fuse Pump Relay to see if it is giving powere to the pump, check the fuse for the Fuel Pump.

Will wait to hear

Check the air control hoses for the cruise control.

Pull up on the brake pedal. If that does not work check your brake light bulbs (LED brake lights will also keep your cruise control form working). Finally check all of the fuses. This system needs at least 3 different fuses to work properly.