Wiper relay
SOURCE: E.E.C fuse keeps blowing in 1991 Ford Explorer
if you replaced fuel pump i would look at backward wiring when replaced and i would start at the source of work if your vehicle was working fine before replacement then 9 out of 10 it will be your fuel pump wireing
sometimes when putting wireing back together the connectors have the missing clip and in turn you can turn the wireing in both directions now where positive is touching the ground on both sides of connector kris kross problem check your work this is crucial use a test light to find the right wires where they go
SOURCE: Front wipers not working right
Hey paul. It sounds to me like it is in the switch itself. I had a ford truck that some wiper options quit working on and it took replacing the blinker switch.
SOURCE: I have a1992 ford explorer the front and rear wipers quit workin
check for power at the wiper motor. If power at the wiper motor but no wiper action then replace the motor. if no power at the motor then use a jumper wire and put power to the motor. Does motor run? if so check for open circuit in the wire someplace.
SOURCE: winshield wiper works on high
Either the wiper switch or the wiper motor. The wiper switch is basically a variable resistor. Those can go bad with repeated use. Usually when the motor goes bad, you'll start to see the wipers pause at the top or bottom of their cycle.
192 views
Usually answered in minutes!
×