Engine light won't go out

Question edited for clarity.
Question moved to Category.

Here are your fuses

Chevrolet Malibu (2000) - fuse box diagram - Auto Genius

https://www.autogenius.info > chevrolet-malibu-2000-f...

Jan 22, 2018 - The engine compartment fuse block is located on the driver's side of the engine compartment, near the air cleaner filter. A.I.R. A.I.R.

There is no fuse and it is a known issue!

https://www.google.com/search?q=2000+Chevrolet+Malibu+tail+light+not+working

..

Question edited for clarity.
Question moved to Chevy Malibu.

There is a good video on removing and replacing the check engine light bulb on a Mustang.

https://www.google.com/search?q=chevy+malibu%2C+change+the+%27Check+Engine+Light%27+light+bulb

Here are videos on removing the gauge cluster on a Malibu.

https://www.google.com/search?q=2011+chevy+malibu+remove+gauge+cluster

..

Chevrolet Malibu Questions - SECURITY SYSTEM LIGHT ...

www.cargurus.com > Questions > Chevrolet > Malibu

CarGurusFeb 3, 2014 - SECURITY SYSTEM LIGHT COMES ON - CAR TURNS OVER WON[T START ... Insert the ignition key into the driver door lock. ... When I start my car 3 keys programmed pops up on my dashboard what does that mean.

Chevrolet Malibu Questions - Why does the anti theft system ...

www.cargurus.com > Questions > Chevrolet > Malibu

CarGurusFeb 23, 2011 - Why does the anti theft system keep tripping on my 03 malibu - Every other day my anti-theft system goes off in my car then I have to reset it. It's not ha... ...it needs a pass lock sensor/ ignition lock cylinder. 10 out of 10 people think ... Wait 10 minutes until the light stops flashing, then start. Repairs could run ...

No Start Due to Failed Passlock Sensor : Chevrolet Malibu ...

repairpal.com > Problems > Chevrolet > Malibu

check the ground leg to your engine.. it runs off the neg. battery terminal. will connect to frame and engine.. pull it off, wire brush it put it back.. you radio will work, 'cause it draws much less current, and is grounded in dash.

replace thermostat did bleed coolant system check coolant level.because if not engine could have overheated and blowed headgaskets warp or cracked the heads check engine compression.sound like engine got too hot.

Hi Bill, The fault light will not go out until you have had the fault attended to. The problem is in the coil not the plugs. Even after replacing that you will need to have the fault code cancelled with the use of a scan tool. Regards John

If the engine was overheated, you most likely have a cracked cylinder head and/or a blown head gasket. The reason it won't start is because there is angine coolant getting in the combution chambers. (You cannot run the engine on antifreeze)

All three light don't work or just the lower ones? Have you checked for power at the switch on the pedal with a test light?

P1665 Evap vent solenoid control circuit

have you checked for corrosion on the battery cables or tryed to jump it or had the battery tested