SOURCE: installing new brake pads on 2000 hyundai Accent GL
REMOVAL
1.
Remove the lower bolt and lift the caliper assembly up and secure it with a wire or some other retaining method.
2.
Remove the pads.
CAUTION: Do not depress the brake pedal while disassembling the pads
INSPECTION
1.
Check the pads for wear or oil contamination and replace, if necessary.
•
The pads for the right and left wheels should be replaced at the same time. Never "drop" or intermix brake pad sets.
•
All four pads must be replaced as a complete set.
•
When replacing the brake pad, check for deformation. When replacing the guide spring, use a new one or the used one after cleaning away foreign material.
2.
Check the pad for damage or deformation.
Brake pad thickness:
Standard value: 9 mm (0.354 in.)
Service limited value: 2 mm (0.0787 in.)
INSTALLATION
1.
Install the pad clips.
2.
Install the pads onto each pad clip.
3.
Insert the piston in the cylinder using the Special Tool (09581-11000).
4.
Install the new pads. The shims are attached to each pad as illustrated
Be careful so that the disc or pad isn't contaminated by grease.
5.
Install the bolt and tighten to the specified value.
Tightening torque
Guide rod bolt: 22~32 Nm(220~320 kgf·cm, 16~24 lb·ft)
SOURCE: 2000 Hyundai Accent GL check engine
i just replaced the timing belt, and asked the garage to look at the transmission for me because i thought i was experiencing some subtle shifting problems. they told me the transmission looked fine, but i needed a new filter and fluid. the engine light didnt turn on til a couple weeks later tho. does this sound like a new filter and fluid would fix this problem?
SOURCE: Replacing bulb (Headlight) in 2000 accent GL
once you pop the hood, there should be a cover behind the light housing that you twist to open the backing.. inside the housing will be a spring lever that secures the bulb down... unhook the spring and disconnect the harness connecting to the bulb...
SOURCE: The key wont turn in the ignition of my hyundai
hi from uk please try this ? with key removed try gently turning steerwheel to the right if you feel a slight spring in steering ? hold on the spring and insert key it should work and release lockand turn ign on ? if steering is springing on left ? try as above the same method not unusual for steer lock to prevent turning key as the steering even in straight position ? the necessity to gently release load on lock is req'd to allow key to turn/unlock the steering lock from the steering column practice doing the above each time you fit key to unlock steering and tuning ign on to start hope this helps
SOURCE: Unlocking the steering wheel
You'll need to have it diagnosed. Without actually looking at it myself, there are numerous possible causes and to take you through each one would take days.
637 views
Usually answered in minutes!
×