1990 Ford Ranger SuperCab Logo

Related Topics:

Posted on Mar 26, 2012

I have a 90 ford ranger 2.3 every morning I have to sit there and let the fuel pump run.. Till it turns off if I start it or try to start it before then it either won't start or runs like ****... I need help anyone knows what I can do to fix this!?!?!?!?!

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Greenhorn:

A rookie expert who has answered 20 questions on their first day.

  • Contributor 24 Answers
  • Posted on Mar 26, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Greenhorn:

A rookie expert who has answered 20 questions on their first day.

Joined: Mar 26, 2012
Answers
24
Questions
0
Helped
7097
Points
78

Replace fuel pump relay then test fuel pressure it should not drop no more then 10psi below factory specs

5 Related Answers

Anonymous

  • 3533 Answers
  • Posted on Jan 09, 2009

SOURCE: Truck Won't Start At All

before replacing the starter get a volt meter and test the voltage coming out of the voltage regulator which the power comes from the battery to the regulator down to the starter also make sure all wires on the starter are clean and what I mean is from rust because I had an f150 that did the same thing

Ad

Anonymous

  • 218 Answers
  • Posted on May 05, 2009

SOURCE: fuel pump will not run

THERE IS A FUEL PUMP SHUT OFF SWITCH(INERTIA) ON THE PASSENGER SIDE KICK PANEL.INSIDE CAB UNDER DASH.IT INTERUPTS POWER TO THE PUMP IF U ARE IN A COLLISION.PUSH THE RED BUTTON ON TOP OF IT.IF THAT DOES NOT WORK CHECK FOR POWER IN AND POWER OUT.NO POWER OUT BAD SWITCH.NO POWER IN OTHER PROBLEM

Anonymous

  • 407 Answers
  • Posted on May 07, 2009

SOURCE: fuel pump will not run power is not going through

look at pass. side kick panel and make sure emergency shut off switch was not activated, make sure red button is pushed in all the way

Anonymous

  • 10 Answers
  • Posted on Jun 13, 2009

SOURCE: have a 86 ford ranger 2.3 l 4cy in mornings

its your fule filter theres 2 of them i the 86 ford ranger you need to change them the location of the fule filters are on google just tipe in fule filter 1986 ford ranger location it should pop up there about 8 dollors a peace easy fix and your truck is like new also get a new battey if you havent k have a good day. oh i know this because i own one had the same problem

Anonymous

  • 708 Answers
  • Posted on Oct 07, 2009

SOURCE: 2002 ford ranger fuel pump..truck won't start

you probably sucked all of the dirt in your tank into the filter. try changing your filter. turn key on and have some listen by the gas tank for a humming sound to test the fuel pump and see if it is working.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Not start after sitting

Try turning the key just to on. Listen for the fuel pump to run and quit. try this 2 or 3 times then attempt to start . if this works it may indicate a leak in the fuel system. Hope this helps
0helpful
1answer

2000 Ford Ranger hard to start:

Unfortunately there are many things that could be causing this. I would check the engine coolant temp. sensor ..and see what its reading with the engine hot. Your going to need a scan tool to get that reading...or just change the sensor...good luck
0helpful
1answer

Ford ranger 1996 4.0L v6 single cab long bed it runs but you have 2 have your foot on the gas it does not stay in idle for more than 5min less than that usually it does not take much gas pedal pressure to...

I would suspect that you have a failing fuel pump, the fuel pump pressure is bleeding off due to a faulty check valve, this causes hard starting esp when cold or after sitting. The fuel pump is located inside the fuel tank, the fuel tank must be removed to replace the fuel pump assembly.
3helpful
2answers

I have a 87 ford ranger 2.9 4+4 replaced both fuel pumps and fuel pump regulator when it sits for over night it looses fuel psi so when i start it in the morning it acts like it has no fuel but after a...

Without seeing it it is a hard thing to diagnose. You could have an injector leaking, possibly a fuel line. Do you smell gas? Sometimes with fords around the fuel filter leaks because of a broken clamp. The o rings around the fuel injectors could be leaking, or one of the rubber fuel lines. If you go off road alot, you could have a pin hole in one of the rubber or metal lines. Check and get back with me and I will do the best I can to help. Hope tis helps.
0helpful
1answer

Are their 2 fuel pumps in a 1987 ford ranger 2.3?

On your year whether it be an extended cab or regular cab there is only one fuel pump.They usually run in the area of 90 to 95 dollars and not to bad to change as long as the tank is just about empty.
2helpful
1answer

My 2001 ford ranger is hard to start turn the key for 5 seconds let off turn again and starts right up let it sit for 15 to 29 min and hard to start again changed injectors plugs and coil pack runs better...

sounds like fuel pressure bleeding off. Bad fuel pump or bad pressure regulator on fuel rail. Can you hear pump run for 5 seconds when you turn key on? do this twice, 30 deconds apart and see if it starts ok.
0helpful
3answers

94 Ford Ranger starting problems

I would check the coolant temp sensor.
2helpful
1answer

2001 ranger wont start after sitting

check the fuel pump and see is working properly, if the pump is good than the problems will be the crank sensor is faulty. what crank sensor does it sense the turning of the flywheel and it send a single to ecu, and ecu send a flow of power to turn on the fuel pump as long it sense the flywheel turning.
0helpful
1answer

2001 ford ranger after it sits for a few hours it

No not the fuel pump. You most likely need to do a tune uo. New spark plugs, wires, fuel filter, air filter. Deffinently change out the spark plugs. I would suggest using autocraft, autolite (fords brand} or some densos or ngk for better performance. Hope this solves your problem.
0helpful
1answer

Have a 86 ford ranger 2.3 l 4cy in mornings

its your fule filter theres 2 of them i the 86 ford ranger you need to change them the location of the fule filters are on google just tipe in fule filter 1986 ford ranger location it should pop up there about 8 dollors a peace easy fix and your truck is like new also get a new battey if you havent k have a good day. oh i know this because i own one had the same problem
Not finding what you are looking for?

381 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...