Will not start new battery the car drags once everytime i try to start and starter gets hot

If starter doesn't spin everytime. Clean battery terminals and a connection. Check connection at starter. Try putting into neutral to start. If starter still doesn't turn car over everytime. Probably starter solenoid. If starter spins every time and doesn't start check temperature sensor. My car once started only when sitting for a couple of hours. Because sensor was saying it was really cold and it would flood it. Had to push gas peddle to floor and hold it there until started. If that is the case change temperature sensor. If car is after mid 90s take and get it scanned.

Well it could be an engine problem, or a bad connection with one of the battery cables. The engine would require more voltage to crank when it is hot, but not that much.
You might want to have someone check the engine to see how much drag is has when hot, by turning the crank by hand.

if starter is not engaging or clicks then have battery load tested. if battery checks good then test the voltage draw on the starter,may be dragging when it gets hot.

The starter is going out. Starters will drag when hot

Check the start solenoid, starter side, when you turn the key... The battery side will always be hot, the starter side should be hot when you turn the key.

check the neutral safty switch

An older starter will sometimes fail to turn over when hot because the armature bushing expand and are too tight for the armature to spin. At this point it is time for a new or rebuilt starter. Shielding it will not really help because it is bolted to the engine and as the engine gets hot the heat will transfer to the starter through conduction and it still will not start.

Hope this helps.
Rich

You had a short circuit. You may have to replace all the wiring going to the starter and from the starter. Check the relays and switches.repair as many wires as you can and see what can be repaired and what cannot.

It sounds like you have the Starter Solinoid Wires Crossed if the Battery cables are getting hot.

is it shimmed correctly?