SOURCE: Cam Shaft Position Sensor 1998 Saturn SL
Have a look at this link, scroll to your engine & click on picture to expand for better view.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528017e904
SOURCE: solution for 1998 saturn sl
Hello DTC P0341 & P0133 very common saturn Codes.You need to check condition of Plugs & wires,If not New Replace All Plugs & Wires,also I would replace the #1#4 Coil for the P0341.For the P0133 Reaplce your front O2 sensor with an OEM sensor,not an aftermarket.
SOURCE: can:t find horn relay location on 1998 saturn sl-1
There are relay and fuse panels under the hood to the rear of the battery and to the left, under a pop off panel, of the front passenger's left knee.
SOURCE: how do i unclog the radiator on a 1998 Saturn sl?
Your car's radiator and cooling system needs to be clean to be cool. As
time goes on, your car's radiator builds solid deposits that can clog
the cooling system. A quick, inexpensive radiator flush which can be purchased at any reputable store (Autozone, Nappa, etc.) can keep the
system in shape. It's important to change your antifreeze seasonally. Before
you start your radiator flush, make sure you have everything you need.
There's nothing worse than draining your radiator only to realize that
you need to drive to the auto store for something! Make sure to clear up clogs or you may soon clog up your thermostat, water pump causing your car to overheat and/or heater core leaving you cold in the winter.
What you'll need to perform a radiator flush:
*Be sure to let your engine cool completely before you loosen or remove the radiator cap. Hot coolant can be painful!
I hope this helps and good luck. Please vote and leave a message.
SOURCE: where's the transmission dipstick on a 2000 saturn sl
The Saturn L series automatic transmissions do not have a dipstick. They are the "new breed" of transmissions that are SUPPOSED to be trouble free. There is a plug on the passenger side of the transmission by the drive axle It is 11mm bolt. start the vehicle in park on a level surface or hoist...at operating temp pull out the plug Fluid should just trickle out of the plug hole If no fluid comes out add fluid to trans until it does...Where do you add??? Red plug on top/center of trans. Plastic plugthat threads in Add fluid there....Good luck
141 views
Usually answered in minutes!
×